Bush Hog RMB 1445 manual Driveline Attachment

Page 49

ASSEMBLY

DRIVELINE ATTACHMENT

Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft. To ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a shield. Entanglement in rotating shafts can kill.

Measure distance shown between the tractor PTO Shaft and mower pump shaft. The driveline must collapse to 3” less than the measured dimension. It may be necessary to shorten the shaft. See Maintenance Section for procedures.

NOTE: The dimensions measured may vary on different tractors. If moving the mower to a different tractor, complete the measurement step again. If it is necessary to shorten the shaft, there must be at least 6” of shaft overlap in the operating position.

Fit PTO shaft and attach torque chain to prevent the shaft guard from rotating. (Figure Asm-B-0094) Raise the stand legs into the work position and secure. (Figure Asm-B-0095)

RMB 1445 11/10

Assembly Section 3-7

© 2010 Alamo Group Inc.

ASSEMBLY

Image 49
Contents RMB To the Owner/Operator/Dealer Warranty InformationPage Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Hydraulic Hoses Page Safety Section Safety Operator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices Safety Stop Mowing if Passersby are Within 300 Feet Unless Safety SGM-06 SGM-08 Maintenance and Service Safety Instructions and Practices Safety Parts Information Transporting Safety Instructions and PracticesSafety Concluding Safety Instructions and Practices Decal Location Name NFS Serial PlateLogo BookletNFS SER PLT InstructMULTI-DECAL Decal Description Safety Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection Tractor Preparation Installing the Operator Guard Cab TractorFactors that affect stability BallastStabilizer Attachment Dealer Setup InstructionsTOP Link Attachment Driveline Attachment Hose Routing Remove Transport StrapOIL Requirements Final Assembly ChecksTank ISO VG SAEGearbox Fitting Control Unit in CABRemoval from Tractor Running UP ProcedureRMB 1445/1660/1865 With Flail Head only Page Operation Section Operation Operation Personal Protective Equipment PPE Operator RequirementsRops and Seat Belt Tractor RequirementsOperator Thrown Object Protection Tractor Ballast Tractor Lighting and SMV EmblemTractor Horsepower Tractor Safety DevicesFront End Weight 3-Point HitchGetting on and OFF the Tractor Power Take Off PTODismounting the Tractor Boarding the TractorStarting the Tractor PRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/Service Boom Unit Pre-Operation Inspection and Service Boom ARM Assembly Frame AssemblyHydraulic Line Inspection Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Implement Do not Operate an Unsafe Tractor or Mower Machine Controls Reversing Rotation With Flailhead Rotor ControlsEngaging Drive Angle FloatRotor Operating Speed Tractor Position Forward SpeedOperating Speed Parallel Motion GeometryHigh Voltage Cables Breakaway ActionCutting Sequence Grass Cutting Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Driving the Tractor and Boom Operating the Tractor and ImplementOperating Instructions RMB 1445 11/10 Operation Section Foreign Debris Hazards Bystanders/Passersby PrecautionsEngaging the Power Take Off PTO Operating the Mower Operating Speed and Ground SpeedSGM-08 Grass Flail Operating the Attached Mower HeadsSickle Bar Shutting Down the Attached Head TRACTOR, BOOM, and Attached Head StorageTransporting the Tractor and Implement Transporting on Public Roadways Operation Hauling the Tractor and Implement Operation Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Operation Maintenance Section Lubrication MaintenancePTO Lubrication PTO ShaftCutting PTO Shaft Maintenance Hose Replacement Filtration MaintenanceHydraulic System Hydraulic HosesPTO Gearbox Hose WarrantyCables FlailheadProper Torque Values for Fasteners Hose ConnectionsMain Control Valve Maintenance Page Limited Warranty Required of the Operator Required of the OwnerRMB 1445 Rear Mount Boom Mower