
Operation | Cutting Height Adjustment |
| ||
|
| |||
| ! | WARNING | ! | |
| DO NOT attempt any maintenance, adjustments or service | |||
| with engine and blade running. STOP engine and blade. | |||
| Remove starter insert. Disconnect spark plug wire and |
| ||
| secure away from spark plug. Engine and components are | |||
A | HOT. Avoid serious burns, allow sufficient time for all com- | |||
ponents to cool. |
|
| ||
Figure 7: Propelling the mower | Pull the cutting height adjust lever (A, Figure 9) | |||
outward, and move to the desired cutting height. | ||||
| ||||
| The highest cutting position is Notch 9, and the | |||
Handle Height Adjustment | lowest cutting position is Notch 1 (Figure 10). The | |||
lever will set all wheels to the same cutting height. |
! | WARNING | ! |
| |
DO NOT attempt any maintenance, adjustments or service |
| |||
|
| Reproduction | ||
with engine and blade running. STOP engine and blade. |
| |||
Remove starter insert. Disconnect spark plug wire and | A | |||
secure away from spark plug. Engine and components are | ||||
HOT. Avoid serious burns, allow sufficient time for all com- |
| |||
ponents to cool. |
|
|
|
|
For greater operator comfort, the height of the mower |
| |||
handle can be adjusted. |
|
|
| |
1. Remove the handle knobs, washers and carriage |
| |||
bolts from the lower handle (A, Figure 8). |
| |||
NOTE: Do not remove the lower set of handle hard- |
| |||
ware (C). |
|
|
|
|
2. Align the handle assembly with one of the th ee | Figure 9: Adjusting cutting height | |||
handle height adjustment holes (B). | 1, tighten- | |||
3. Replace the hardware removed in St |
| |||
ing securely. |
|
|
| Mulching Operation |
|
|
|
| |
|
|
|
| For best mulching results, cut up to a maximum of 1/3 |
|
|
|
| of grass length and recycle ONLY when grass is dry. |
|
|
|
| 1. Make sure the discharge deflector and grass bag |
|
|
|
| are removed, and the mulching plug is installed. |
B |
|
|
| 2. Set the cutting height adjust lever in the highest |
|
|
| cutting position (Notch 9). | |
|
|
|
| 3. Proceed mowing slowly. Gradually lower the cut- |
|
|
|
| ting height to obtain the best combination of cut- |
A |
|
|
| ting and mulching performance. Cutting too much |
| C |
| grass in one pass, or cutting wet heavy grass may | |
|
|
| cause clumping or plugging of the mower deck. | |
Figure 8: Adjusting the handle height |
|
|
14 | www.brutepower.com |