Exmark Lazer Z XS manual Safe Zone for Mowing

Page 10

DANGER

POTENTIAL HAZARD

Mowing on wet grass or steep slopes can cause sliding and loss of control.

WHAT CAN HAPPEN

Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning.

HOW TO AVOID THE HAZARD

Do not mow slopes when grass is wet.

Do not mow near drop-offs or near water.

Do not mow slopes greater than 15 degrees.

Reduce speed and use extreme caution on slopes.

Avoid sudden turns or rapid speed changes.

See inside the back cover to determine the approximate slope angle of the area to be mowed.

Use a walk behind mower and/or a hand trimmer near drop-offs, ditches, steep banks or water. This area can be dangerous, see Figure 1.

Figure 1

SAFE ZONE FOR MOWING

Progressively greater care is needed as the slope increases.

Always avoid sudden starting or stopping on a slope. If tires lose traction, disengage the blades and proceed slowly off the slope.

Avoid sudden starts when mowing uphill. Mower may tip backwards.

Be aware that loss of traction may occur going downhill. Weight transfer to the front wheels may cause drive wheels to slip and cause loss of braking and steering.

Watch for ditches, holes, rocks, dips, and rises that change the operating angle, as rough terrain could overturn the machine.

Remove or mark obstacles such as rocks, tree limbs, etc. from the mowing area. Tall grass can hide obstacles.

Use extreme care with grass catchers or attachments. These can change the stability of the machine and cause loss of control.

Follow the manufacturer’s recommendations for wheel weights or counterweights to improve stability.

1.4.5A Rollover Protection System (roll bar) is installed on the unit.

- 5 -

Image 10
Contents For Serial Nos 440,000 & Higher Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Safety Alert Symbol SafetyYour Safety is Involved TrainingCarbon monoxide can kill you Potential Hazard Operation Safe Zone for Mowing There is no rollover protection when the roll bar is down Maintenance and Storage Safety Signs Do not Operate Without Guard Location Rubber Heat Shield Specifications Tires Hydrostatic Ground Drive SystemCutting Deck Uncrate Mower Install Rollover Protection System Roll BAR Assembly InstructionsDimensions Torque RequirementsLower Roll BAR Installation Upper Roll BAR Installation Service BatteryMachine is shipped with a filled lead acid battery Install Seat Install Motion Control LeversPosition Discharge Chute Service Engine Service Hydraulic OILCheck Tire Pressure Controls Operation InstructionsMotion Control Positions Push the lever forward and down to disengage the brake PRE-START Operating InstructionsRotating blades under the mower deck are dangerous Transporting Periodic Maintenance Maintenance & AdjustmentsService Interval Daily Service Interval Monthly Service Interval Daily or more often in dry conditionsService Interval Daily Blade Bolt Installation Check rollover protections systems roll bar pins Service Interval 40 hrs Service Interval 40 hrService Interval Refer to chart Service Interval Once Yearly Lubrication ChartCaster Wheel Assembly Service Interval 160 hrs Service Interval After First 250 hrs Then yearly thereafter Service Interval As RequiredService Interval 500 hrs Adjustments Cutting Height PositionANTI-SCALP Roller Adjustment Swivel Adjustment Spring Compression Adjustment Self-tensioning No adjustment necessaryMule Drive Belt Adjustment Belt Guide PositioningNo adjustment necessary Brake AdjustmentThrottle Tension Reverse Indicator Adjustment Motion Control Adjustment Waste Disposal Mercury Switch DisposalCaster Adjustment Motor OIL DisposalMower Pulls Left or Right W/LEVERS Fully Forward Trouble ShootingBattery Disposal Mower Cuts UnevenlyEngine Troubleshooting Table ProblemElectrical Diagram Hydraulic Diagram Limited Warranty Exmark Turf Equipment Service Record Page See EXMARK’S Complete Line of Products for Turf Care