Exmark Lazer Z XS manual Maintenance and Storage

Page 12

1.4.17Do Not mow with the discharge deflector raised, removed or altered unless there is a grass collection system or mulch kit in place and working properly.

1.4.18Be aware of the mower discharge and direct discharge away from others.

1.4.19Do Not operate mower under the influence of alcohol or drugs.

1.4.20Use extra care when approaching blind corners, shrubs, trees, or other objects that may obscure vision.

1.4.21If jump starting is required:

a)connect the positive (+) power cable from the positive post on the booster battery to the positive terminal post on the starter solenoid switch (this post has the positive battery cable attached to it).

b)connect the negative or ground cable (-) from the negative post on the booster battery to the engine block as far away from the battery as possible.

c)disconnect battery cables in the reverse order after starting.

1.5MAINTENANCE AND STORAGE

1.5.1For engine maintenance, follow the engine manufacturer’s recommendations precisely as stated in the engine manual.

1.5.2Disconnect the battery cable from the negative battery post when the unit will be allowed to sit for more than 30 days without use.

1.5.3Allowing batteries to stand for an extended period of time without recharging them will result in reduced performance and service life. To preserve optimum battery performance and life, recharge batteries in storage when the open circuit voltage drops to 12.4 volts.

Note: To prevent damage due to freezing, battery should be fully charged before putting away for winter storage.

1.5.4Keep engine, engine area, and pump drive belt compartment free from accumulation of grass, leaves, excessive grease or oil, and other debris which can accumulate in these areas. These materials can become combustible and may result in a fire.

1.5.5Store fuel in a container specifically designed for this purpose in a cool, dry place.

1.5.6Keep the mower and fuel container in locked storage to prevent children from playing or tampering with them.

1.5.7Gasoline powered equipment or fuel containers should not be stored in a basement or any enclosed area where open pilot lights or heat appliances are present.

1.5.8Maximum mowing results and safety can only be achieved if the mower is

properly maintained and operated correctly.

1.5.9Check all bolts frequently to maintain proper tightness.

1.5.10Keep all guards, shields, and all safety devices in place and in safe working condition.

1.5.11Frequently check for worn or deteriorating components that could create a hazard.

1.5.12All replacement parts must be the same as or equivalent to the parts supplied as original equipment.

- 7 -

Image 12
Contents For Serial Nos 440,000 & Higher Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Safety Your Safety is InvolvedSafety Alert Symbol TrainingCarbon monoxide can kill you Potential Hazard Operation Safe Zone for Mowing There is no rollover protection when the roll bar is down Maintenance and Storage Safety Signs Do not Operate Without Guard Location Rubber Heat Shield Specifications Hydrostatic Ground Drive System TiresCutting Deck Assembly Instructions DimensionsUncrate Mower Install Rollover Protection System Roll BAR Torque RequirementsLower Roll BAR Installation Service Battery Upper Roll BAR InstallationMachine is shipped with a filled lead acid battery Install Seat Install Motion Control LeversService Engine Service Hydraulic OIL Position Discharge ChuteCheck Tire Pressure Operation Instructions ControlsMotion Control Positions Push the lever forward and down to disengage the brake PRE-START Operating InstructionsRotating blades under the mower deck are dangerous Transporting Maintenance & Adjustments Periodic MaintenanceService Interval Daily Service Interval Monthly Service Interval Daily or more often in dry conditionsService Interval Daily Blade Bolt Installation Check rollover protections systems roll bar pins Service Interval 40 hr Service Interval 40 hrsService Interval Refer to chart Lubrication Chart Service Interval Once YearlyCaster Wheel Assembly Service Interval 160 hrs Service Interval As Required Service Interval After First 250 hrs Then yearly thereafterService Interval 500 hrs Adjustments Cutting Height PositionANTI-SCALP Roller Adjustment Swivel Adjustment Spring Compression Adjustment Self-tensioning No adjustment necessaryMule Drive Belt Adjustment Belt Guide PositioningBrake Adjustment No adjustment necessaryThrottle Tension Reverse Indicator Adjustment Motion Control Adjustment Mercury Switch Disposal Caster AdjustmentWaste Disposal Motor OIL DisposalTrouble Shooting Battery DisposalMower Pulls Left or Right W/LEVERS Fully Forward Mower Cuts UnevenlyEngine Troubleshooting Table ProblemElectrical Diagram Hydraulic Diagram Limited Warranty Exmark Turf Equipment Service Record Page See EXMARK’S Complete Line of Products for Turf Care