Husqvarna Rider 318, Rider 320 AWD manual Fitting the cutting head, Trapping your hand

Page 21

Maintenance

Fitting the cutting head

WARNING! Wear protective glasses when

!ﬁtting the cutting unit. The spring which tensions up the belt may break and cause personal injury.

1Place the Rider on a ﬂat surface and apply the parking brake.

2Check that the lever for setting the cutting height is in the lowest position and that the lifting lever for the cutting unit is in mowing position.

3Push the equipment frame down and place the catch against the frame.

4 Engage the belt in the belt holder.

5Push the deck in and put the front guide plugs in the grooves on the equipment frame, one on each side.

WARNING! Observe caution to avoid

!trapping your hand.

6 Lift up the cutting unit

7Push the unit in so that the interior plugs touch the bottom of the equipment frame’s grooves.

8Fit the drive belt around the drive wheels of the cutting unit. Make sure the belt is placed on the correct side of the belt tensioner wheel.

9 Hook up the height adjustment strut.

10 Secure the collet spring.

11 Fit the front cover.

English – 21

Image 21

Contents Rider 318 Rider 320 AWD Contents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Introduction Symbols KEY to SymbolsKEY to Symbols Location of the controls What is WHAT?Safety instructions Safety InstructionsInsure your Rider General useThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Fueling SeatRelease lever Release lever RiderBefore starting DrivingStart the engine Starting a cold engineConnecting the jump leads Starting the engine with a weak batteryDriving the Rider Stop the engineMaintenance schedule MaintenanceCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Adjusting the parking brake Rider 320 AWD Adjusting the parking brake RiderChecking and adjusting of throttle wire Can result in reduced braking abilityReplacing the air ﬁlter Replacement of fuel ﬁlterChecking the fuel pump’s air ﬁlter Cool before starting to replace the air ﬁlterIgnition system Check the safety systemMain fuse Checking the tyre pressureTrapping your hand Fitting the cutting headAdjusting the parallelism of the cutting unit Removing the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Replacing the blades Checking the bladesRemoving the BioClip plug Combi 103, CombiChecking the engine’s oil level LubricationChanging the oil ﬁlter Replacing the engine oilLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Storage ServiceWinter storage GuardTechnical Data EC Declaration of Conformity Applies to Europe only Cutting unit CombiBlade Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨