Husqvarna Rider 318, Rider 320 AWD Service journal, Pre-delivery service, After the first 8 hours

Page 3

Service journal

Pre-delivery service

1Charge the battery for 4 hours at max. 3 amp.

2Fit steering wheel, seat and any optional equipment.

3Check and adjust tyre pressure. (60 kPa, 0.6 bar, 9 psi).

4Adjust cutting unit:

Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).

Adjust cutting unit so that rear edge is about 2-4 mm / 1/8” higher than front edge.

Adjust the cutting unit’s cutting height setting so that the connection rod is tensed at the lowest cutting height.

5Check that the right amount of oil is in the engine.

6Check that there is oil in the transmission’s oil tank.

7Connect battery.

8Fill with fuel and start engine.

9Check that machine does not move in neutral.

10Check: Forward drive.

Reverse drive.

Operation of blades.

Seat safety switch.

Lif lever safety switch.

The safety switch for the hydrostat pedals.

11Check the engine speed See the Technical data section.

12Check front and rear wheel rotation speed according to the service schedule. (Only AWD- machines) See the workshop manual.

13Tell customer about:

Needs and benefits of following the service schedule.

Servicing and the influence of this journal on the second-hand value of the machine.

Range of applications for BioClip.

Complete proof of sale etc.

Pre-delivery service carried out. No outstanding problems. Certified:

________________________________________________

Date, mileage, stamp, signature

After the first 8 hours

1 Change engine oil

2Change the oil in the gearbox. (Only AWD- machines)

3Check front and rear wheel rotation speed according to the service schedule. (Only AWD- machines) See the workshop manual.

English – 3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Rider 318 Rider 320 AWD Contents Service journal Pre-delivery serviceAfter the first 8 hours Introduction Symbols KEY to SymbolsKEY to Symbols Location of the controls What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Release lever Rider SeatFueling Release leverStarting a cold engine DrivingBefore starting Start the engineStop the engine Starting the engine with a weak batteryConnecting the jump leads Driving the RiderMaintenance schedule MaintenanceCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Can result in reduced braking ability Adjusting the parking brake RiderAdjusting the parking brake Rider 320 AWD Checking and adjusting of throttle wireCool before starting to replace the air filter Replacement of fuel filterReplacing the air filter Checking the fuel pump’s air filterChecking the tyre pressure Check the safety systemIgnition system Main fuseTrapping your hand Fitting the cutting headAdjusting the parallelism of the cutting unit Removing the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Combi 103, Combi Checking the bladesReplacing the blades Removing the BioClip plugReplacing the engine oil LubricationChecking the engine’s oil level Changing the oil filterLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Guard ServiceStorage Winter storageTechnical Data EC Declaration of Conformity Applies to Europe only Cutting unit CombiBlade Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨
Top Page Image Contents