Husqvarna Rider 318, Rider 320 AWD manual Driving on slopes, This is what you do

Page 9

SAFETY INSTRUCTIONS

Never allow children or other persons not trained in the use of the machine to use or service it. Local laws may regulate the age of the user.

WARNING! You must use approved personal

!protective equipment whenever you use the machine. Personal protective equipment cannot eliminate the risk of injury but it will reduce the degree of injury if an accident does happen. Ask your dealer for help in choosing the right equipment.

Use hearing protection to minimise the risk of hearing impairment.

Never wear loose-fitting clothing, jewellery or similar that can get caught in moving parts.

Never use the machine when barefoot. Always wear protective shoes or protective boots, preferably with steel toes.

Make sure that you have first aid equipment close at hand when using the machine.

Driving on slopes

Driving on slopes is one of the operations where the risk of the driver losing control of the machine or of it overturning is the greatest; this can result in serious injury or death. All slopes demand extra care. If you cannot reverse up a slope or if you feel unsure, do not mow it.

IMPORTANT INFORMATION

Do not drive down slopes with the cutting deck raised.

This is what you do

Remove obstacles such as stones, branches, etc.

Mow upwards and downwards, not sideways.

>10

Do not use the machine on ground that slopes more than 10°.

Take extra care if any attachments are fitted that can change the stability of the machine.

Avoid starting or stopping on a slope. If the tyres start to slip, stop the blades and drive slowly down the slope.

Always drive smoothly and slowly on slopes.

Do not make any sudden changes in speed or direction.

Avoid unnecessary turns on slopes, if necessary, turn slowly and gradually downwards if possible. Drive slowly. Do not turn the wheel sharply.

Watch out for and avoid driving over furrows, holes and bumps. It is easier for the machine to overturn on uneven ground. Tall grass can hide obstacles.

Do not mow too close to edges, ditches or banks. The machine can suddenly overturn if one wheel comes over the edge of a steep slope or a ditch, or if an edge gives way.

Do not mow wet grass. It is slippery, and tyres can lose their grip so that the machine skids.

English – 9

Image 9
Contents Rider 318 Rider 320 AWD Contents Service journal Pre-delivery serviceAfter the first 8 hours Introduction Symbols KEY to SymbolsKEY to Symbols Location of the controls What is WHAT?Safety instructions Safety InstructionsInsure your Rider General useThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Fueling SeatRelease lever Release lever RiderBefore starting DrivingStart the engine Starting a cold engineConnecting the jump leads Starting the engine with a weak batteryDriving the Rider Stop the engineMaintenance schedule MaintenanceCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Adjusting the parking brake Rider 320 AWD Adjusting the parking brake RiderChecking and adjusting of throttle wire Can result in reduced braking abilityReplacing the air filter Replacement of fuel filterChecking the fuel pump’s air filter Cool before starting to replace the air filterIgnition system Check the safety systemMain fuse Checking the tyre pressureTrapping your hand Fitting the cutting headAdjusting the parallelism of the cutting unit Removing the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Replacing the blades Checking the bladesRemoving the BioClip plug Combi 103, CombiChecking the engine’s oil level LubricationChanging the oil filter Replacing the engine oilLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Storage ServiceWinter storage GuardTechnical Data EC Declaration of Conformity Applies to Europe only Cutting unit CombiBlade Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨