Husqvarna Rider 318, Rider 320 AWD manual KEY to Symbols

Page 5

KEY TO SYMBOLS

Symbols

These symbols are on the machine and in the instructions.

WARNING! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved hearing protection

This product is in accordance with applicable

EC directives.

Fast

Slow

Stop the engine.

Choke.

Fuel

Oil level

Cutting height

Backwards

Forwards

Ignition

Hydrostatic freewheel

Parking brake

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in the Technical data chapter and on the label.

Clutch in

Clutch out

Warning: rotating parts. Keep hands and feet clear.

Rotary blades Keep hands and feet away from under the hood when the engine is running

Hot surface.

Risk that the machine will tip over

Never drive across a slope

>10

Never use the machine if persons, especially children, or animals, are in the vicinity

Never carry passengers on the machine or equipment

Drive very slowly if no cutting unit is ﬁtted

Before and during reversing procedures, look behind you.

Brake

English – 5

Image 5

Contents Rider 318 Rider 320 AWD Contents After the ﬁrst 8 hours Service journalPre-delivery service Introduction Symbols KEY to SymbolsKEY to Symbols Location of the controls What is WHAT?Safety instructions Safety InstructionsInsure your Rider General useThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Fueling SeatRelease lever Release lever RiderBefore starting DrivingStart the engine Starting a cold engineConnecting the jump leads Starting the engine with a weak batteryDriving the Rider Stop the engineMaintenance schedule MaintenanceRemoving of the machine hoods CleaningChecking and adjusting the steering wires Adjusting the parking brake Rider 320 AWD Adjusting the parking brake RiderChecking and adjusting of throttle wire Can result in reduced braking abilityReplacing the air ﬁlter Replacement of fuel ﬁlterChecking the fuel pump’s air ﬁlter Cool before starting to replace the air ﬁlterIgnition system Check the safety systemMain fuse Checking the tyre pressureTrapping your hand Fitting the cutting headChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitRemoving the cutting unit Replacing the cutting unit belts Restoring from service position Service position for the cutting unitPlacing in the service position Replacing the blades Checking the bladesRemoving the BioClip plug Combi 103, CombiChecking the engine’s oil level LubricationChanging the oil ﬁlter Replacing the engine oilGeneral lubrication Lubricating the belt adjusterChecking the transmission oil level Troubleshooting schedule Storage ServiceWinter storage GuardTechnical Data Blade EC Declaration of Conformity Applies to Europe onlyCutting unit Combi Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨