Husqvarna Rider 320 AWD, Rider 318 manual KEY to Symbols

Page 6

KEY TO SYMBOLS

Starting instructions

Switch off the engine and

take off the ignition cable before repairs or maintenance

Check the engine’s oil level

Check transmission oil level

Lift up the cutting unit

Apply the parking brake.

If the engine is cold, use the choke

Release the parking brake before driving

6 – English

Image 6

Contents Rider 318 Rider 320 AWD Contents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Introduction KEY to Symbols SymbolsKEY to Symbols What is WHAT? Location of the controlsInsure your Rider Safety InstructionsSafety instructions General useDriving on slopes This is what you doMaintenance ChildrenTransport Presentation Release lever SeatFueling Release lever RiderStart the engine DrivingBefore starting Starting a cold engineDriving the Rider Starting the engine with a weak batteryConnecting the jump leads Stop the engineMaintenance Maintenance scheduleCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Checking and adjusting of throttle wire Adjusting the parking brake RiderAdjusting the parking brake Rider 320 AWD Can result in reduced braking abilityChecking the fuel pump’s air ﬁlter Replacement of fuel ﬁlterReplacing the air ﬁlter Cool before starting to replace the air ﬁlterMain fuse Check the safety systemIgnition system Checking the tyre pressureFitting the cutting head Trapping your handAdjusting the parallelism of the cutting unit Removing the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Removing the BioClip plug Checking the bladesReplacing the blades Combi 103, CombiChanging the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oilLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Winter storage ServiceStorage GuardTechnical Data EC Declaration of Conformity Applies to Europe only Cutting unit CombiBlade 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨ Original instructions