Husqvarna Rider 318, Rider 320 AWD manual What is WHAT?, Location of the controls

Page 7

WHAT IS WHAT?

1	2		3	4	5	6	7	8
	9	10		11	12	13		14	15

Location of the controls

1	Speed limiter for driving forward	9	Parking brake
2	Speed limiter for reversing	10	Lock button for parking brake
3	Lifting lever for the cutting unit	11	Seat adjustment.
4	Cutting height adjustment lever	12	Lever to disengage the driving front axle, Rider 320 AWD
5	Ignition lock	13	Fuel cap
6	Throttle control/choke control	14	Battery
7	Counter	15	Lever to disengage the drive, Rider 318. Lever to
8	Cover lock		disengage the driving rear axle, 320 AWD.
8	Cover lock

English – 7

Image 7

Contents Rider 318 Rider 320 AWD Contents Pre-delivery service Service journalAfter the ﬁrst 8 hours Introduction Symbols KEY to SymbolsKEY to Symbols Location of the controls What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Release lever Rider SeatFueling Release leverStarting a cold engine DrivingBefore starting Start the engineStop the engine Starting the engine with a weak batteryConnecting the jump leads Driving the RiderMaintenance schedule MaintenanceChecking and adjusting the steering wires CleaningRemoving of the machine hoods Can result in reduced braking ability Adjusting the parking brake RiderAdjusting the parking brake Rider 320 AWD Checking and adjusting of throttle wireCool before starting to replace the air ﬁlter Replacement of fuel ﬁlterReplacing the air ﬁlter Checking the fuel pump’s air ﬁlterChecking the tyre pressure Check the safety systemIgnition system Main fuseTrapping your hand Fitting the cutting headRemoving the cutting unit Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Placing in the service position Service position for the cutting unitRestoring from service position Combi 103, Combi Checking the bladesReplacing the blades Removing the BioClip plugReplacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlterChecking the transmission oil level Lubricating the belt adjusterGeneral lubrication Troubleshooting schedule Guard ServiceStorage Winter storageTechnical Data Cutting unit Combi EC Declaration of Conformity Applies to Europe onlyBlade Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨