Husqvarna Essential Lubrication Tips for Lawn Mowers
Page 27

Lubrication

Checking the transmission oil level

1Remove the transmission cover. Undo the two screws (one on each side) and lift off the transmission cover.

2 Check that there is oil in the transmission’s oil tank.

Rider 318 Fill if necessary with engine oil SAE 10W/40 (class SF–CC).

Rider 320 AWD Fill if necessary with oil Synthetic 10W/50

The oil and filter should be changed by an authorised service representative, as described in the Workshop Manual.

Work on the system entails particular demands on cleanliness and the system must be vented before the machine is used.

Lubricating the belt adjuster

The belt adjuster should be lubricated regularly using good quality molybdenum disulphide grease*.

•Unscrew the belt shield.

•Lubricate using a grease gun, 1 nipple from the right-hand side under the engine’s lower belt pulley, until grease is forced out. With daily use, lubrication should be carried out twice weekly.

•Screw on the belt shield.

General lubrication

All joints and bearings are lubricated using molybdenum disulphide grease during manufacture. Continue to lubricate using the same type of grease *. Lubricate the steering and control wires using engine oil.

Carry out this lubrication regularly; with daily use, the machine should be lubricated twice weekly.

*Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality. The most important property is that the grease provides good protection against corrosion.

English – 27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Rider 318 Rider 320 AWD Contents Service journal Pre-delivery serviceAfter the first 8 hours Introduction Symbols KEY to SymbolsKEY to Symbols Location of the controls What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Release lever Rider SeatFueling Release leverStarting a cold engine DrivingBefore starting Start the engineStop the engine Starting the engine with a weak batteryConnecting the jump leads Driving the RiderMaintenance schedule MaintenanceCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Can result in reduced braking ability Adjusting the parking brake RiderAdjusting the parking brake Rider 320 AWD Checking and adjusting of throttle wireCool before starting to replace the air filter Replacement of fuel filterReplacing the air filter Checking the fuel pump’s air filterChecking the tyre pressure Check the safety systemIgnition system Main fuseTrapping your hand Fitting the cutting headAdjusting the parallelism of the cutting unit Removing the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Combi 103, Combi Checking the bladesReplacing the blades Removing the BioClip plugReplacing the engine oil LubricationChecking the engine’s oil level Changing the oil filterLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Guard ServiceStorage Winter storageTechnical Data EC Declaration of Conformity Applies to Europe only Cutting unit CombiBlade Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨
Top Page Image Contents