Husqvarna LZ30, LZ30C, LZ7230, LZ6127, LZ5227, LZ6130 Or into anything. If necessary, make repairs

Page 15

SAFETY

Ensure that nuts and bolts, especially the fastening bolts for the blade attachments, are properly tightened, torqued and that the equipment is in good condition.

Do not modify safety equipment. Check regularly to be sure it works properly. The machine must not be driven with defective or unmounted protective plates, protective cowlings, safety switches, or other protective devices.

Do not change the settings of governors and avoid running the engine with overly high engine speeds. If you run the engine too fast, you risk damaging the machine components.

Sparking can occur when working with the battery and the heavy cables of the starter circuit. This can cause battery explosion, fire or eye injury. Sparking in this circuit can not occur after the chassis cable (normally negative, black) is removed from the battery.

6003-009

Do not smoke when performing maintenance on the battery. The battery can explode and cause serious injury/damage.

WARNING!

Avoid electrical sparking and its consequences by the following routines:

Use protective goggles.

 

Ensure that the fuel filler cap is mounted tightly

 

 

and no flammable substances is stored in an

 

 

open vessel.

 

Never work with the starter circuit if there is

 

 

spilled fuel.

 

Disconnect the chassis cable from the battery

 

 

first and reconnect it last.

 

Do not make a bridge short circuit across the

 

 

starter relay to run the starter.

 

• Never use the machine indoors or in spaces

 

 

lacking proper ventilation. The exhaust fumes

 

 

contain carbon monoxide, an odorless,

 

 

poisonous, and lethal gas.

 

Stop and inspect the equipment if you run over

8009-728

or into anything. If necessary, make repairs

Risk of sparking

before starting.

 

Never make adjustments with the engine running.

The machine is tested and approved only with the equipment originally provided or recommended by the manufacturer. Only use approved repair parts for the machine.

English-15

Image 15
Contents Operator Manual Page Contents English-4 Introduction Manufacturing Number Good ServiceImportant Information Symbols and DecalsRemove key before Safety Safety InstructionsGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Or into anything. If necessary, make repairs Customer responsibilities TransportSpark Arresters Roll over Protection system RopsControls ControlsMotion Control Levers Hour meter Tracking knobParking Brake Blade switch Ignition SwitchFuses Refueling Seat adjustment lever Seat LockFuel shut off valve Choke control Throttle controlLifting Lever for the Mower Deck Accessories Cutting height lift pedalPump release valves Steering OperationOperation TrainingRoll bar and safety belt Before StartingStarting the Engine Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Mowing no choke To start an engine with a weak battery To attach jumper cablesTo remove cables, reverse order Running Mower deck’s gauge wheels should be evenly adjustedOperating on hills Mowing Tips Moving by Hand Stopping the Engine25 50 100 MaintenanceLeast Hours Once Maintenance Before After Each Daily Weekly100 300 Battery To clean battery and terminalsReplacing battery Ignition System Safety SystemSafety system Engine Cooling Air Intake Throttle CableChoke Cable Air filter housing and filter Air FilterDust cap Engine Oil Cooler Fuel Pump Air Filter Fuel FilterChecking the V-belts Deck beltTo replace deck belt Pump belt Checking Tire PressuresChecking the Parking Brake Checking the Blades Blade replacementAdjusting the Mower Deck Adjusting Cutting HeightLeveling Hardware Cleaning and WashingRemoval and installation of caster wheel Caster WheelsLubrication Schedule LubricationLubricating the Cables Shaft Bushings and LinkageLubricating with Lubrication Schedule Engine Oil Changing the Engine Oil Checking the Oil Level Oil Type Oil RecommendationsFront Wheel Bearings Mower Deck Height AdjusterThrottle and Choke Cables, Lever Bearings Front Wheel MountSteering Control Shafts Mower Deck StrutsChanging the Oil Filter Problem Cause Troubleshooting GuideEnglish-58 Service StorageWinter Storage For unit produced before Serial No Wiring DiagramsTechnical Data LZ5227 LZ6127 EngineTransmission Overall Dimensions LZ5227 Z6127Productivity LZ6130 LZ7230 Engine LZ6130C LZ7230C LZ6130 LZ7230 LZ30C LZ30Torque Specifications Conformity Certificates Conformity Certificates USA requirementsCE requirements Action Date, mtr reading, stamp, sign Service JournalService Journal Delivery ServiceAfter the First 5-8 Hours Hour Service English-71 English-72 English-73 At Least Once Each Year English-75 Warranty Statement 539 131254 R01 08/23/07