Husqvarna LZ6130C, LZ7230C, LZ7230, LZ6127 Engine Cooling Air Intake, Throttle Cable, Choke Cable

Page 41

MAINTENANCE

Engine Cooling Air Intake

Check that the engine’s cooling air intake is free from leaves, grass, and dirt.

If the cooling air intake is clogged, engine cooling deteriorates, which can lead to engine damage.

Throttle Cable

Check that the engine responds to throttle increases and that a good engine speed is attained at full throttle.

If doubts arise, contact the service workshop.

If adjustments are necessary, locate the engine cables mounted under the air filter housing. The throttle cable sits on the right side of the engine.

1.Loosen the clamping screw for the cable’s outer casing and move the throttle to the full throttle position.

2.Check that the throttle cable is mounted in the middle hole in the throttle lever.

3.Push the throttle cable’s outer casing as far to the left as possible and tighten the clamping screw.

8011-780

Check and clean the cooling air intake

Choke Cable

If the engine produces black smoke or is difficult to start, this can be because the choke cable is incorrectly adjusted (upper cable).

If doubts arise, contact the service workshop.

If adjustments are necessary, they can be made as follows:

1.Loosen the clamping screw for the cable’s outer casing and move the choke lever to the full choke position.

2.Check that the choke cable is mounted in the upper lever, see illustration. Push the choke cable’s outer casing as far to the right as possible and tighten the clamping screw.

English-41

Image 41
Contents Operator Manual Page Contents English-4 Introduction Manufacturing Number Good ServiceImportant Information Symbols and DecalsRemove key before General Operation SafetySafety Instructions Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Or into anything. If necessary, make repairs Customer responsibilities TransportSpark Arresters Roll over Protection system RopsControls ControlsMotion Control Levers Parking Brake Hour meterTracking knob Fuses Blade switchIgnition Switch Refueling Fuel shut off valve Seat adjustment leverSeat Lock Lifting Lever for the Mower Deck Choke controlThrottle control Pump release valves AccessoriesCutting height lift pedal Operation OperationTraining SteeringStarting the Engine Roll bar and safety beltBefore Starting Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Mowing no choke To remove cables, reverse order To start an engine with a weak batteryTo attach jumper cables Running Mower deck’s gauge wheels should be evenly adjustedOperating on hills Mowing Tips Moving by Hand Stopping the EngineLeast Hours Once Maintenance Before After Each MaintenanceDaily Weekly 25 50 100100 300 Replacing battery BatteryTo clean battery and terminals Ignition System Safety SystemSafety system Choke Cable Engine Cooling Air IntakeThrottle Cable Dust cap Air filter housing and filterAir Filter Engine Oil Cooler Fuel Pump Air Filter Fuel FilterTo replace deck belt Checking the V-beltsDeck belt Checking the Parking Brake Pump beltChecking Tire Pressures Checking the Blades Blade replacementLeveling Adjusting the Mower DeckAdjusting Cutting Height Removal and installation of caster wheel Cleaning and WashingCaster Wheels HardwareLubrication Schedule LubricationLubricating with Lubrication Schedule Lubricating the CablesShaft Bushings and Linkage Engine Oil Changing the Engine Oil Checking the Oil Level Oil Type Oil RecommendationsThrottle and Choke Cables, Lever Bearings Mower Deck Height AdjusterFront Wheel Mount Front Wheel BearingsChanging the Oil Filter Steering Control ShaftsMower Deck Struts Problem Cause Troubleshooting GuideEnglish-58 Winter Storage ServiceStorage For unit produced before Serial No Wiring DiagramsTransmission Technical DataLZ5227 LZ6127 Engine Productivity Overall DimensionsLZ5227 Z6127 LZ6130 LZ7230 Engine LZ6130C LZ7230C LZ6130 LZ7230 LZ30C LZ30Torque Specifications CE requirements Conformity CertificatesConformity Certificates USA requirements Service Journal Service JournalDelivery Service Action Date, mtr reading, stamp, signAfter the First 5-8 Hours Hour Service English-71 English-72 English-73 At Least Once Each Year English-75 Warranty Statement 539 131254 R01 08/23/07