Husqvarna LZ5227, LZ6130, LZ7230, LZ6127, LZ6130C, LZ7230C, LZ30, LZ30C manual Refueling

Page 22

CONTROLS

Refueling

Read the safety instructions before refueling. The machine has two fuel tanks, one on each side just behind the seat. The tank capacity is 3 gallons (11.4 liters).

Regularly check the gas cap gasket for damage and keep the cap properly tightened.

The engine will run on a minimum of 85-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See Technical Data concerning ethanol fuel. Methanol fuel is not allowed. Do not use E85 alcohol based fuel. Damage to the engine and components may occur.

When operating in temperatures below 32° F. (0° C.), use fresh, clean winter grade gasoline to help insure good cold weather starting.

WARNING!

Gasoline is highly flammable. Observe caution and fill the tank outdoors (see the safety instruction).

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before refueling

WARNING!

Fill to bottom of filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

8011-524

Fuel tanks

IMPORTANT INFORMATION

Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel the next season. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur.

English-22

Image 22
Contents Operator Manual Page Contents English-4 Introduction Good Service Manufacturing NumberSymbols and Decals Important InformationRemove key before Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Or into anything. If necessary, make repairs Transport Customer responsibilitiesRoll over Protection system Rops Spark ArrestersControls ControlsMotion Control Levers Tracking knob Hour meterParking Brake Ignition Switch Blade switchFuses Refueling Seat Lock Seat adjustment leverFuel shut off valve Throttle control Choke controlLifting Lever for the Mower Deck Cutting height lift pedal AccessoriesPump release valves Training OperationOperation SteeringBefore Starting Roll bar and safety beltStarting the Engine Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Mowing no choke To attach jumper cables To start an engine with a weak batteryTo remove cables, reverse order Mower deck’s gauge wheels should be evenly adjusted RunningOperating on hills Mowing Tips Stopping the Engine Moving by HandDaily Weekly MaintenanceLeast Hours Once Maintenance Before After Each 25 50 100100 300 To clean battery and terminals BatteryReplacing battery Safety System Ignition SystemSafety system Throttle Cable Engine Cooling Air IntakeChoke Cable Air Filter Air filter housing and filterDust cap Engine Oil Cooler Fuel Filter Fuel Pump Air FilterDeck belt Checking the V-beltsTo replace deck belt Checking Tire Pressures Pump beltChecking the Parking Brake Blade replacement Checking the BladesAdjusting Cutting Height Adjusting the Mower DeckLeveling Caster Wheels Cleaning and WashingRemoval and installation of caster wheel HardwareLubrication Lubrication ScheduleShaft Bushings and Linkage Lubricating the CablesLubricating with Lubrication Schedule Engine Oil Changing the Engine Oil Checking the Oil Level Oil Recommendations Oil TypeFront Wheel Mount Mower Deck Height AdjusterThrottle and Choke Cables, Lever Bearings Front Wheel BearingsMower Deck Struts Steering Control ShaftsChanging the Oil Filter Troubleshooting Guide Problem CauseEnglish-58 Storage ServiceWinter Storage Wiring Diagrams For unit produced before Serial NoLZ5227 LZ6127 Engine Technical DataTransmission LZ5227 Z6127 Overall DimensionsProductivity LZ6130 LZ7230 Engine LZ6130C LZ7230C LZ6130 LZ7230 LZ30 LZ30CTorque Specifications Conformity Certificates USA requirements Conformity CertificatesCE requirements Delivery Service Service JournalService Journal Action Date, mtr reading, stamp, signAfter the First 5-8 Hours Hour Service English-71 English-72 English-73 At Least Once Each Year English-75 Warranty Statement 539 131254 R01 08/23/07