Husqvarna LZ30, LZ30C manual Throttle and Choke Cables, Lever Bearings, Front Wheel Mount

Page 55

LUBRICATION

Throttle and Choke Cables, Lever Bearings

Lubricate the cable ends by the carburetor with the oil can. Move the controls to the end points and lubricate again.

The throttle cable is also lubricated by the control when the control console is removed.

On Kohler engine the cables are placed under the air filter housing.

Front Wheel Mount

Lubricate with a grease gun, one zerk for each wheel mount, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

Front Wheel Bearings

Lubricate with a grease gun, one zerk for each set of wheel bearings, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

Deck belt pulleys

Lubricate with a grease gun two strokes.

Mower Deck Height Adjuster

Lubricate using a grease gun, one zerk, until the grease squeezes out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

8011-573-

Lubricating the front wheels

8011-461

Deck belt pulley

8011-574

Lubricating the cutting height adjuster

English-55

Image 55
Contents Operator Manual Page Contents English-4 Introduction Manufacturing Number Good ServiceImportant Information Symbols and DecalsRemove key before Safety Instructions SafetyGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Or into anything. If necessary, make repairs Customer responsibilities TransportSpark Arresters Roll over Protection system RopsControls ControlsMotion Control Levers Tracking knob Hour meterParking Brake Ignition Switch Blade switchFuses Refueling Seat Lock Seat adjustment leverFuel shut off valve Throttle control Choke controlLifting Lever for the Mower Deck Cutting height lift pedal AccessoriesPump release valves Steering OperationOperation TrainingBefore Starting Roll bar and safety beltStarting the Engine Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Mowing no choke To attach jumper cables To start an engine with a weak batteryTo remove cables, reverse order Running Mower deck’s gauge wheels should be evenly adjustedOperating on hills Mowing Tips Moving by Hand Stopping the Engine25 50 100 MaintenanceLeast Hours Once Maintenance Before After Each Daily Weekly100 300 To clean battery and terminals BatteryReplacing battery Ignition System Safety SystemSafety system Throttle Cable Engine Cooling Air IntakeChoke Cable Air Filter Air filter housing and filterDust cap Engine Oil Cooler Fuel Pump Air Filter Fuel FilterDeck belt Checking the V-beltsTo replace deck belt Checking Tire Pressures Pump beltChecking the Parking Brake Checking the Blades Blade replacementAdjusting Cutting Height Adjusting the Mower DeckLeveling Hardware Cleaning and WashingRemoval and installation of caster wheel Caster WheelsLubrication Schedule LubricationShaft Bushings and Linkage Lubricating the CablesLubricating with Lubrication Schedule Engine Oil Changing the Engine Oil Checking the Oil Level Oil Type Oil RecommendationsFront Wheel Bearings Mower Deck Height AdjusterThrottle and Choke Cables, Lever Bearings Front Wheel MountMower Deck Struts Steering Control ShaftsChanging the Oil Filter Problem Cause Troubleshooting GuideEnglish-58 Storage ServiceWinter Storage For unit produced before Serial No Wiring DiagramsLZ5227 LZ6127 Engine Technical DataTransmission LZ5227 Z6127 Overall DimensionsProductivity LZ6130 LZ7230 Engine LZ6130C LZ7230C LZ6130 LZ7230 LZ30C LZ30Torque Specifications Conformity Certificates USA requirements Conformity CertificatesCE requirements Action Date, mtr reading, stamp, sign Service JournalService Journal Delivery ServiceAfter the First 5-8 Hours Hour Service English-71 English-72 English-73 At Least Once Each Year English-75 Warranty Statement 539 131254 R01 08/23/07