Husqvarna LZ7230, LZ6127 Steering Control Shafts, Mower Deck Struts, Changing the Oil Filter

Page 56

LUBRICATION

Steering Control Shafts

Tip the driver’s seat.

Lubricate with a grease gun, one zerk for each steering control shaft, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

Mower Deck Struts

Lubricate with a grease gun, one zerk for each strut, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

8011-578

Lubricating the steering control shafts

8011-577-1

Lubricating struts

Changing the Oil Filter

1.Drain the engine oil in accordance with the work description under the heading “Engine

Oil/Change Engine Oil”.

2. Remove the oil filter. If necessary, use a filter remover.

3. Wipe new, clean engine oil onto the seal for the new filter.

4. Mount the filter by hand with a ¾ turn.

5. Run the engine warm, then check that there are no leaks around the oil filter seal.

6. Check the oil level in the engine, top up if necessary. The oil filter holds 0.2 qt.

(0.2 liters) of oil.

8011-745

Changing the oil filter

English-56

Image 56
Contents Operator Manual Page Contents English-4 Introduction Good Service Manufacturing NumberSymbols and Decals Important InformationRemove key before General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Or into anything. If necessary, make repairs Transport Customer responsibilitiesRoll over Protection system Rops Spark ArrestersControls ControlsMotion Control Levers Parking Brake Hour meterTracking knob Fuses Blade switchIgnition Switch Refueling Fuel shut off valve Seat adjustment leverSeat Lock Lifting Lever for the Mower Deck Choke controlThrottle control Pump release valves AccessoriesCutting height lift pedal Operation OperationTraining SteeringStarting the Engine Roll bar and safety beltBefore Starting Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Mowing no choke To remove cables, reverse order To start an engine with a weak batteryTo attach jumper cables Mower deck’s gauge wheels should be evenly adjusted RunningOperating on hills Mowing Tips Stopping the Engine Moving by HandMaintenance Least Hours Once Maintenance Before After EachDaily Weekly 25 50 100100 300 Replacing battery BatteryTo clean battery and terminals Safety System Ignition SystemSafety system Choke Cable Engine Cooling Air IntakeThrottle Cable Dust cap Air filter housing and filterAir Filter Engine Oil Cooler Fuel Filter Fuel Pump Air FilterTo replace deck belt Checking the V-beltsDeck belt Checking the Parking Brake Pump beltChecking Tire Pressures Blade replacement Checking the BladesLeveling Adjusting the Mower DeckAdjusting Cutting Height Cleaning and Washing Removal and installation of caster wheelCaster Wheels HardwareLubrication Lubrication ScheduleLubricating with Lubrication Schedule Lubricating the CablesShaft Bushings and Linkage Engine Oil Changing the Engine Oil Checking the Oil Level Oil Recommendations Oil TypeMower Deck Height Adjuster Throttle and Choke Cables, Lever BearingsFront Wheel Mount Front Wheel BearingsChanging the Oil Filter Steering Control ShaftsMower Deck Struts Troubleshooting Guide Problem CauseEnglish-58 Winter Storage ServiceStorage Wiring Diagrams For unit produced before Serial NoTransmission Technical DataLZ5227 LZ6127 Engine Productivity Overall DimensionsLZ5227 Z6127 LZ6130 LZ7230 Engine LZ6130C LZ7230C LZ6130 LZ7230 LZ30 LZ30CTorque Specifications CE requirements Conformity CertificatesConformity Certificates USA requirements Service Journal Service JournalDelivery Service Action Date, mtr reading, stamp, signAfter the First 5-8 Hours Hour Service English-71 English-72 English-73 At Least Once Each Year English-75 Warranty Statement 539 131254 R01 08/23/07