MAINTENANCE
Pump belt
Check belt every 100 hours for excessive wear.
To replace belt. Relieve tension on the deck belt and remove deck belt from clutch. See “Deck belt” section. Loosen bolt on the clutch tie down and rotate out of the way.
Using a ½" drive ratchet inserted into the square hole in the pump idler arm, relieve the tension on the pump belt and remove belt.
To reinstall the belt, swing pump idler pulley toward engine to route belt around it. Then route belt around the pulley for left pump first (right hand pulley in the illustration).
Reinstall idler spring and use the ratchet to rotate idler so the belt may be installed all the way around the last pulley.
Checking Tire Pressures
All four tires should have a pressure of 15 psi / 103 kPa /1 bar.
Checking the Parking Brake
Visually check that no damage is found on the lever, links, or switch belonging to the parking brake. Perform a test drive and check that there is sufficient braking action.
To adjust the parking brake, contact the Husqvarna service workshop.
WARNING!
Faulty adjustment of the parking brake can cause an accident.
Slackening the belt tension
Belt routing, hydraulic pumps
Released parking brake