Multi-Tech Systems MT3410ZLX When Using V.42bis or MNP5, Some Features Are Disabled, Connect

MultiMobile Owner’s Manual

When Using V.42bis or MNP5, Some Features Are Disabled

C: You may be using a non-streaming protocol, like Xmodem or Ymodem to transfer files. Those are fine unless you are using V.42bis or MNP5

S: When using V.42bis or MNP5, you should use a streaming transfer protocol like Ymodem-G or Zmodem.

S: Configure your software to use hardware flow control (RTS/CTS ON).

When Connecting to Another Modem, the Modem Reports a Higher Connect Baud Rate than it Is Really Using

C: The modem defaults to report the modem-to- computer baud rate when it responds with

CONNECT.

S: Go to Command mode with your communication program (like Telix) and type ATW2, then press Enter. This tells the modem to report the modem-to-modem baud rate instead.

When I Run CARDEN, “PC-Card Is Not Enabled Successfully” Is Displayed

C: Your computer does not have enough memory to map the attribute memory of your MT3410ZLX.

S: If memory management software (e.g., EMM386) is installed, you must reserve an area in upper memory (C000:0 — EFFF:F) for MT3410ZLX attribute memory when enabling the card.

44