MultiMobile Owner’s Manual
Command | Options Function & Description |
En | AT command echo options |
E0 | Echo disabled |
E1* | Echo enabled |
Hn | |
H0 | Modem goes |
H1 | Modem goes |
Mn | Speaker control |
M0 | Speaker always off |
M1 * | Speaker on until carrier present |
M2 | Speaker always on |
M3 | Speaker off during dialing and on until |
| carrier present |
Nn | Select negotiate handshake |
N0 | When originating or answering, |
| handshake only at the communication |
| rate specified by S37 register and |
| “ATBn” and no fallback |
N1 * | When originating or answering, start |
| handshaking only at the |
| communication standard specified by |
| S37 register and “ATBn” During |
| handshake, fallback to a lower speed |
| may occur except in “AT\N1” mode |
On | Go |
O0 | Return modem to a previously |
| established state |
O1 | Begin an equalizer retrain sequence, |
| then return to |
O3 to O14 | Force modem to a new rate that is |
| user defined. New rates are defined in |
| S62 register |
P | Enable pulse dialing |
Qn | Result code display options |
Q0 * | Result code enabled |
* Factory default setting
62
