Accton Technology ES4710BD manual Netbios-name-server, Netbios-node-type

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

Command: lease { [<days>] [<hours>][<minutes>] infinite } no lease

Function: Sets the lease time for addresses in the address pool; the “no lease” command restores the default setting.

Parameters: <days> is number of days from 0 to 365; <hours is number of hours from 0 to 23;

<minutes> is number of minutes from 0 to 59; infinite means perpetual use. Default: The default lease duration is 1 day.

Command Mode: DHCP Address Pool Mode

Usage Guide: DHCP is the protocol to assign network addresses dynamically instead of permanently, hence the introduction of ease duration. Lease settings should be decided based on network conditions: too long lease duration offsets the flexibility of DHCP, while too short duration results in increased network traffic and overhead. The default lease duration of ES4710BD is 1 day.

Example: Setting the lease of DHCP pool “1” to 3 days 12 hours and 30 minutes. Switch(dhcp-1-config)#lease 3 12 30

14.2.2.14 netbios-name-server

Command: netbios-name-server <address1>[<address2>[…<address8>]] no netbios-name-server

Function: Configures WINS servers’ address; the “no netbios-name-server” command deletes the WINS server.

Parameters: address1…address8 are IP addresses, in decimal format.

Default: No WINS server is configured by default.

Command Mode: DHCP Address Pool Mode

Usage Guide: This command is used to specify WINS server for the client, up to 8 WINS server addresses can be configured. The WINS server address assigned first has the highest priority. Therefore, address 1 has the highest priority, and address 2 the second, and so on.

14.2.2.15 netbios-node-type

Command: netbios-node-type ｛b-nodeh-nodem-nodep-node<type-number>｝no netbios-node-type

Function: Sets the node type for the specified port; the “no netbios-node-type” command cancels the setting.

Parameters: b-nodestands for broadcasting node, h-nodefor hybrid node that broadcasts after point-to-point communication; m-nodefor hybrid node to communicate in point-to-point after broadcast; p-nodefor point-to-point node; <type-number>is the node type in Hex from 0 to FF.

Default: No client node type is specified by default.

Command Mode: DHCP Address Pool Mode

Usage Guide: If client node type is to be specified, it is recommended to set the client node type to

305