ES4710BD 10 Slots L2/L3/L4 Chassis Switch
00:17:52: PIM: Received v2 Join/Prune on Vlan2 from 192.3.1.3 to 192.3.1.2
00:17:52: PIM: Receive
00:17:54: PIM: Received v2 Hello on Vlan4 from 192.4.1.4, holdtime 105
00:17:57: PIM: Received v2 Hello on vlan3 from 192.2.1.1, holdtime 105
00:17:57: PIM: Received v2 Hello on Vlan2 from 192.3.1.3, holdtime 105
00:17:58: PIM: Received v2 Hello on Vlan4 from 192.4.1.3, holdtime 105
00:18:21: PIM: Send v2 Hello on vlan2, holdtime 105
00:18:21: PIM: Send v2 Hello on vlan4, holdtime 105
00:18:21: PIM: Send v2 Hello on vlan3, holdtime 105
00:18:21: PIM: Send v2 Hello on Vlan4, holdtime 105
00:18:21: PIM: Send v2 Hello on Vlan2, holdtime 105
19.4.4.1.7debug ip pim bsr
Command: debug ip pim bsr
Function: Enables the PIM candidate RP/BSR information debug function; the “no” format of the command disables this debug function.
Parameters: N/A.
Default: Disabled
Command mode: Admin Mode
Usage Guide: If detailed information about PIM candidate RP/BSR packets etc. is required, this debugging command can be used.
Example:
Switch # debug ip pim bsr PIM BSR debug is on
00:16:23: PIM: Received v2 BSR on Vlan4 from 192.4.1.3
00:16:23: PIM: Receive BSR fragtag 6879, hmlen: 30, pri: 192
00:16:23: PIM: Receive BSR Group (225.0.0.1, 0.0.0.0): rpcount: 1, fragcount: 1
00:16:23: PIM:
00:16:23: PIM: Transmit the BSR message on Vlan2
00:16:23: PIM: Transmit the BSR message on vlan4
00:16:23: PIM: Transmit the BSR message on vlan3
00:16:23: PIM: Transmit the BSR message on vlan2
19.4.4.2PIM-SM Troubleshooting
In configuring and using
Good condition of the physical connection.
All interface and link protocols are in the UP state (use “show interface” command).
Multicast protocols use unicast routes to perform RPF checks, for this reason, the unicast route
478
