Accton Technology ES4710BD manual Vrrp Troubleshooting Help, Create Vrrp Number

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

Default: Debugging information is disabled by default.

Command mode: Admin Mode

Example:

Switch#debug vrrp

VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]

VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]

VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]

VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]

21.3.2VRRP Troubleshooting Help

In configuring and using VRRP protocol, the VRRP protocol may fail to run properly due to reasons such as physical connection failure or wrong configurations. The user should ensure the following:

—Good condition of the physical connection.

—All interface and link protocols are in the UP state (use “show interface” command).

—Ensure VRRP is enabled on the interface.

—Verify the authentication mode of different routers (or L3 Ethernet switches) in the same standby cluster are the same.

—Verify the timer time of different routers (or L3 Ethernet switches) in the same standby cluster are the same.

—Verify the dummy IP address is in the same network segment of the interface’s actual IP address.

—If VRRP problems persist after the above-mentioned procedures, please run debug gingcommands like “debug vrrp”, and copy the DEBUG information in 3 minutes and send the information to Edge-Core technical service center.

21.4WEB MANAGEMENT

Click “VRRP control” to enter VRRP control configuration mode to manage VRRP features for the switch.

21.4.1Create VRRP Number

Click “VRRP control” to enter "Create VRRP Number".

Example: Enter 1 for virtual router number and click Apply to create a virtual router with VRRP number 1. Click Remove to remove Virtual Router 1.

543