Accton Technology ES4710BD manual Set router as BSR candidate, Set router as RP candidate

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

19.7.3.4Set router as BSR candidate

Click Set router as BSR candidate for configure PIM-SM candidate BSR information ，for compete with other candidate BSR for BSR router. This is the same as CLI command 19.4.2.2.4

zSet router as BSR candidate － yes means configure the switch as PIM-SM domain candidate BSR；no means cancel switch to configure as candidate BSR

zPort － assign layer 3 interface VLAN ID（select from scroll bar menu）

zHash mask length － assigns hash mask length

zPriority － assigns priority

zApply － runs according to configured parameter

zDefault － cancels switch to configure as candidate BSR

19.7.3.5Set router as RP candidate

Click “Set router as RP candidate” to configure PIM-SM candidate RP information, to compete with other candidate RPs for RP router. This is the same as CLI command 19.4.2.2.5

zSet router as RP candidate － yes means configure switch as candidate PIM-SM RP；no means cancel RP configuration

zPort － assign layer 3 interface VLAN ID（select from scroll bar menu）

zGroup-List － assign access-list ID

zInterval － assign sending candidate RP message interval

zApply － run according to configured parameter

zDefault － cancel RP configuration

19.7.4DVMRP configuration

19.7.4.1Enable DVMRP

In DVMRP protocol configuration mode, click “Enable DVMRP” to enable or disable DVMRP protocol in specific interface. This is the sameas CLI command 19.5.2.2.2

zEnable DVMRP － yes means enable DVMRP protocol; no means disable DVMRP protocol

503