506
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
z IGMP query timeout － Configures IGMP query timeout. This is the same as CLI
command 19.6.2.2.5
z Vlan Port － assigns layer 3 interface（select from scroll bar menu）
z Apply － runs according to configured parameter
z Default － restores the interface configuration parameter to default
(including group filter qualification, query interval, maximum response time,
query timeout），if input relevant group address for static group domain and join group
domain，it will cancel static group or（and）join group in interface.
Note：Because the page correspondence 6 PCS CLI command，A error parameter message will
appear when only configure one or many parameter，it’s not affected.
19.7.5.2 IGMP version configuration
Click “IGMP version configuration” to configure interface IGMP protocol version. This is the same
as CLI command 19.6.2.2.7
z IGMP version configuration － assigns version
z Vlan Port － assigns layer 3 interface（select from scroll bar menu）
z Apply － runs according to configured parameter
z Default － configures version as default
19.7.6 Multicast monitor configuration 19.7.6.1 Show ip pim interface
In multicast protocol monitor mode, click “Show ip pim interface” to display the PIM interface
information. This is the same as CLI command 19.4.4.1.2
19.7.6.2 Show ip pim mroute dm
Click “Show ip pim mroute dm” to display the PIM-DM message forwarding item. This is the same
as CLI command 19.3.4.2
19.7.6.3 Show ip pim neighbor