ES4710BD 10 Slots L2/L3/L4 Chassis Switch
same as CLI command 19.5.2.2.3
zInterval of sending probe packet － Configures the interval of sending probe packet. This is the same as CLI command 19.5.2.2.6
zInterval of sending report packet － Configures the interval of sending report packet. This is the same as CLI command 19.5.2.2.7
zDVMRP route timeout －configures DVMRP route timeout. This is the same as CLI command 19.5.2.2.8
zApply － runs according to configured parameter
zDefault － restores the global configuration parameter to default (includes sending graft, probe, report message interval, dvmrp route timeout）
Note：Because the page correspondence 4 PCS CLI command，it will appear error parameter message when only configure one or many parameter, it’s not affected.
19.7.4.5DVMRP tunnel configuration
Click “DVMRP tunnel configuration to create”, repeal the tunnel which to neighbor DVMRP tunnel . This is the same as CLI command 19.5.2.2.9
zNeighbor ip address － remote neighbor IP address
zMetric － tunnel interface metric
zVlan Port － assigns layer 3 interface（select from scroll bar menu）
zApply － creates DVMRP tunnel to specific neighbor
zDelete tunnel － removes DVMRP tunnel to specific neighbor
19.7.5IGMP configuration
19.7.5.1IGMP additive parameter configuration
In “IGMP protocol configuration mode”, click “IGMP additive parameter configuration” to configure IGMP protocol interface parameters. This is the same as 6 PCS CLI command 19.6.2.2.1, 19.6.2.2.2, 19.6.2.2.3, 19.6.2.2.4, 19.6.2.2.5, 19.6.2.2.6
zSet Acl for IGMP group － Configures interface filter qualifications to IGMP group. This is the same as CLI command 19.6.2.2.1
zAdd interface to IGMP group － Configures interface to join some IGMP group. This is the same as CLI command 19.6.2.2.2
zAdd IGMP static group to VLAN － Configures interface join some IGMP static group. This is the same as CLI command 19.6.2.2.6
zIGMP query interval － Configures IGMP query interval. This is the same as CLI command 19.6.2.2.3
z
505
