Accton Technology ES4710BD manual Ethernet Port Configuration Commands, Bandwidth

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

speed-duplex {auto force10-half	Sets port speed and duplex mode of
force10-full force100-half force100-full	100/1000Base-TX ports. The “no” format of
{ {force1g-half force1g-full}	this command restores the default setting, i.e.,
[nonegotiate [master slave]] } }	negotiates	speed	and	duplex	mode
	automatically.
negotiation {onoff}	Enables/Disables the auto-negotiation function
	of 1000Base-T ports.
bandwidth control <bandwidth> [both	Sets or	cancels the	bandwidth used for
receive transmit]	incoming/outgoing traffic for specified ports
no bandwidth control
flow control	Enables/Disables traffic control function for
no flow control	specified ports
loopback	Enables/Disables loopback test function for
no loopback	specified ports
	Enables the storm control function for
	broadcasts, multicasts and unicasts with
rate-suppression {dlf broadcast	unknown destinations (short for broadcast),
multicast} <packets>	and sets the allowed broadcast packet number;
	the “no” format of this command disables the
	broadcast storm control function.

7.2.1.2Ethernet Port Configuration Commands

7.2.1.2.1bandwidth

Command: bandwidth control <bandwidth> [both receive transmit] no bandwidth control

Function: Enables the bandwidth control function for the port: the “no bandwidth control” command disables the bandwidth control function for the port.

Parameters: <bandwidth> is the bandwidth limit in Mbps, the valid value ranges from 1 to 10000 Mbps; both indicates bandwidth control in both incoming and outgoing traffic; receive means bandwidth control applies to incoming traffic from outside the switch; transmit means bandwidth control applies to outgoing traffic to outside the switch.

Command mode: Interface Mode

Default: Port bandwidth control is disabled by default.

Usage Guide: When bandwidth control is enable for a port, and bandwidth limit is set, then the maximum bandwidth will be limited and no longer be 10/100/1000M line speed. If [both receive transmit] keyword is not specified, it will default to both.

Note: The bandwidth limit set must not exceed the maximum physical connection speed possible of

159