ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Default: Port statistics are not cleared by default.
Usage Guide: If no port is specified, then statistics of all ports will be cleared.
Example: Clearing the statistics for Ethernet port 1/1. Switch#clear counters ethernet 1/1
7.4.1.2show interface
Command: show interface [{ethernet
<port-channel-number> <interface-name>}]
Function: Displays information about specified port.
Parameters:
Command mode: Admin Mode
Default: No port information is displayed by default.
Usage Guide: For Ethernet ports, this command displays information about port speed, duplex mode, traffic control on/off, broadcast storm control and statistics for packets sent/received; for VLAN interfaces, this command displays MAC address, IP address and statistics for packets sent/received; for trunk ports, this command displays port speed, duplex mode, traffic control on/off, broadcast storm control and statistics for packets sent/received. Usage Guide: If no ports are specified, then information for all ports will be displayed.
Example: Displaying information about port 4/1. Switch#show interface ethernet 4/1
7.4.2Port Troubleshooting Help
Here are some situations that frequently occurs in port configuration and the advised solutions:
&Two connected fiber interfaces won’t link up if one interface is set to
&The following combinations are not recommended: enabling traffic control as well as setting multicast limiting for the same port; setting broadcast, multicast and unknown destination unicast control as well as port bandwidth limiting for the same port. If such combinations are set, the port throughput may fall below the expected performance.
7.5WEB MANAGEMENT
Click “Port configuration” to open the port configuration management table. Users can proceed to do port management, setup port speed, duplexes and so on.
175