Accton Technology ES4710BD manual 20.5.2.2 802.1X port authentication configuration

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

suppliant. Equivalent to CLI command 20.2.2.12.

zHolddown time for authentication failure(1-65535 second) - Configures suppliant quiet-period status time after authentication failure. Same as CLI command 20.2.2.13.

zRe-authenticate client interval(1-65535 second) - Configures time interval of switch re-authentication client. Equivalent to CLI command 20.2.2.14.

zResending EAP-request/identity interval(1-65535 second) - Configures time interval of switch retransfer EAP-request/identity frame to suppliant. Equivalent to CLI command 20.2.2.15.

zEAP relay authentication mode - Configures switch to adopt EAP relay method to make authentication; use the “no” command to configure switch to adopt EAP local terminating method to make authentication. Equivalent to CLI command 20.2.2.4.

zMAC filtering – Enables, disables the switch dot1x address filter function. Equivalent to CLI command 20.2.2.6.

Example: Choose 802.1x status as Open 802.1x, Configure Maximum retransmission times of EAP-request/identity as 1, choose Re-authenticate client periodically as Disable Re-authenticate, configure Holddown time for authentication failure as 1, configure Reauthenticate client interval as 1, configure Resending EAP-request/identity interval as 1, choose EAP relay authentication mode as forbid, choose MAC filtering as forbid and then click Apply button to set the configurations.

20.5.2.2802.1X port authentication configuration

Click “Authentication configuration”, “802.1X configuration”, “802.1X port authentication configuration” to Configure port 802.1x function

zPort – assigns port

z802.1x status – port 802.1x status, Open, 802.1x function is open; Close, 802.1x function is close. Same as CLI command 20.2.2.5.

zAuthentication type - Configures port 802.1x authentication status. Auto means enable 802.1x authentication. According to switch and suppliant authentication information, to confirm that the port is in authenticated status or unauthenticated status, force-authorized is configured port as authenticated status, allowing unauthenticated data to pass across the port; for force-unauthorized configure port unauthenticated status, switch not provide suppliant authentication service in this port, not permit any port pass across this port. Same as CLI command 20.2.2.9.

531