Accton Technology ES4710BD manual Network Management Port Configuration Commands, Duplex

	ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Command			Explanation
Global Mode
interface ethernet <num>			Enters the network management
			port configuration mode
2. Configure the properties for the network management port
Command		Explanation
Network Management Port Configuration
shutdown		Enables/Disables network management port
no shutdown
speed {auto force10 force100 }		Sets network management port speed
duplex {auto full half}		Sets network management port duplex mode
loopback		Enables/Disables loopback test function for
no loopback		network management port
ip address <ip-address> <mask>		Configures or cancels the IP address for
no ip address [<ip-address> <mask>]		network management port.

7.2.3.2Network Management Port Configuration Commands

7.2.3.2.1duplex

Command: duplex {auto full half }

Function: Sets network management port duplex mode

Parameters: auto for auto-negotiation full-duplex mode; full for forced full-duplex mode; half for forced half-duplex mode.

Command mode: Network management port configuration Mode

Default: The default duplex mode is set to auto-negotiation.

Usage Guide: According to IEEE 802.3, the auto-negotiation for port speed and duplex are linked. If the duplex setting of the port is auto-negotiation, the port speed will be set to auto-negotiation automatically; if the port duplex mode changes from auto-negotiation to forced full/half-duplex, the port speed will also become forced mode, the forced speed will be the port speed before this command.

It is strongly recommended for the users to set all port speed and duplex mode to auto-negotiation, this can minimize protocol-related connection problems. If forced speed/duplex mode needs to be set, the speed/duplex mode setting of both ends must be verified to be the same.

Example: Setting the network management port to forced full-duplex mode. Switch(Config)#interface ethernet 0 Switch(Config-Ethernet0)#duplex full

168