Accton Technology ES4710BD manual Typical PIM-SM Scenario

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

this command is configured.

Example: Setting the interface vlan1 as the candidate RP announcing message sending interface. Switch (Config)# ip pim rp-candidate vlan1 group-list 5

Switch (Config)# access-list 5 permit 239.255.2.0 0.0.0.255

19.4.3Typical PIM-SM Scenario

As shown in the figure below, the Ethernet interfaces of SWITCHA, SWITCHB, SWITCHC and SWITCHD are added to the appropriate vlan, and PIM-SM protocol is enabled on each vlan interface.

SWITCHA SWITCHB

Ethernet1/2	Et hernet 1/ 1	Et hernet 1/ 1
vl an2	vl an1	vl an1
Ethernet1/2	SWITCHC	Ethernet1/2
vl an2 bsr		vl an2

Et hernet 1/ 2

vl an2 rp

SWITCHD

Ethernet1/3	Ethernet1/1	Ethernet1/1
vl an3	vl an1	vl an1

Ethernet1/3

vl an3

Fig 19-2 Typical PIM-SM environment

The followings are the configurations of SWITCHA, SWITCHB, SWITCHC, and SWITCHD.

(1)Configuration of SWITCHA: Switch (Config)#interface vlan 1 Switch(Config-If-Vlan1)# ip pim sparse-mode Switch(Config-If-Vlan1)#exit

Switch (Config)#interface vlan 2 Switch(Config-If-Vlan2)# ip pim sparse-mode

(2)Configuration of SWITCHB:

Switch (Config)#interface vlan 1

Switch(Config-If-Vlan1)# ip pim sparse-mode

Switch(Config-If-Vlan1)#exit

473