Accton Technology ES4710BD Router id routerid, Scope the no network network mask area, Authkey

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

(3)Configure other OSPF protocol parameters

a.Configure OSPF routing protocol priority

b.Configure cost for OSPF STUB area and default route

c.Configure OSPF virtual link

d.Configure the priority of the interface when electing designated layer 3 switch (DR).

3.Disable OSPF protocol.

1. Enable OSPF protocol

Basic configuration of OSPF routing protocol on ES4710BD series switches is quite simple, usually only enabling OSPF and configuration of the OSPF area for the interface are required. The OSPF protocol parameters can use the default settings. If OSPF protocol parameters need to be modified, please refer to “2. Configure OSPF sub-parameters”.

Command	Explanation
Global Mode
[no] router ospf	Enables	OSPF	protocol; the “no	router ospf”
	command disables OSPF protocol (required)
	Configures the ID number for the layer 3 switch
router id <router_id>	running	OSPF;	the “no router	id” command
	cancels	the ID	number. The IP	address of an
no router id
	interface is selected to be the layer 3 switch ID.
	(optional)
OSPF protocol configuration mode
[no] network <network> <mask> area	Defines several segments in an area to a network
	scope; the “no network <network> <mask> area
<area_id> [ advertise notadvertise ]	<area_id> [ advertise notadvertise ]” command
	cancels the network scope. (optional)
Interface Mode
ip ospf enable area <area_id>	Sets an area for the specified interface; the “no ip
	ospf enable area” command cancels the setting.
no ip ospf enable area
	(required)

2. Configure OSPF sub-parameters

(1)Configure OSPF packet sending mechanism parameters

a.Configure OSPF packet verification

b.Set the OSPF interface to receive only

c.Configure the cost for sending packets from the interface

Command			Explanation
Interface Mode
ip ospf authentication		{ simple	Configures the authentication method and key
<auth_key>	md5	<auth_key>	required by the interface to accept OSPF packets;
<key_id>}			the “no ip ospf authentication” command
no ip ospf authentication			restores the default setting.
[no] ip ospf passive-interface			Sets the interface to receive only, the “no ip ospf
			passive-interface”command cancels the setting.
ip ospf cost <cost >			Sets the cost for running OSPF on the interface;
			the “no ip ospf cost” command restores the
no ip ospf cost
			default setting.
			408