ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Command: port-group <port-group-number> mode {activepassiveon}
no port-group <port-group-number>
Function: Adds a physical port to port channel, the “no
Parameters:
Command mode: Interface Mode
Default: Switch ports do not belong to a port channel by default; LACP not enabled by default.
Usage Guide: If the specified port group does not exist, a group will be created first to add the ports. All ports in a port group must be added in the same mode, i.e., all ports use the mode used by the first port added. Adding a port in “on” mode is a “forced” action, which means the local end switch port aggregation does not rely on the information of the other end, port aggregation will succeed as long as there are 2 or more ports in the group and all ports have consistent VLAN information. Adding a port in “active” or “passive” mode enables LACP. Ports of at least one end must be added in “active” mode, if ports of both ends are added in “passive” mode, the ports will never aggregate.
Example: Under the Port Mode of Ethernet1/1, add current port to
13.2.2.3interface port-channel
Command: interface port-channel <port-channel-number>
Function: Enters the port channel configuration mode
Command mode: Global Mode
Default:
Usage Guide: On entering aggregated port mode, configuration to GVRP or spanning tree modules will apply to aggregated ports; if the aggregated port does not exist (i.e., ports have not been aggregated), an error message will be displayed and configuration will be saved and will be restored until the ports are aggregated. Note such restoration will be performed only once, if an aggregated group is ungrouped and aggregated again, the initial user configuration will not be restored. If it is configuration for modules, such as shutdown or speed configuration, then the configuration to current port will apply to all member ports in the corresponding port group.
Example: Entering configuration mode for
287
