Accton Technology ES4710BD manual Ethernet port configuration, Physical port configuration

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

7.5.1Ethernet port configuration

Click “Port configuration”, “Ethernet port configuration” to open the Ethernet port configuration management table to configure Ethernet port duplex, speed, bandwidth control and so on.

7.5.1.1Physical port configuration

Click “port configuration”, “Ethernet port configuration”, “Physical port configuration” to configure the following information:

zPort: Specifies the configuration port

zMDI: Sets up the connection type of the Ethernet port. Auto means to auto-negotiate connection type; across means the port supporting cross-over cable only; normal means the port supporting straight-through cable only. This function is equal to CLI command 7.2.1.2.6.

zAdmin Status: Enables/Disables port. Equals to CLI command 7.2.1.2.9

zspeed/duplex status: Sets up Ethernet sport speed and duplex including, auto-negotiation, 10Mbps Half, 10Mbps Full, 100Mbps Half, 100Mbps Full, 1000Mbps Half, 1000Mbps Full. Equals to CLI command 7.2.1.2. and 7.2.1.2.10

zPort flow control status: Sets up port flow control including disabled flow control and enabled flow control. Equals to CLI command 7.2.1.2.3

zLoopback: Sets up Ethernet port to enable loopback testing function. Equals to CLI command 7.2.1.2.5

Example: Assign port to be Ethernet 1/1 and set up MDI as normal; Admin control status as no shutdown, speed/duplex as auto, port flow control status as disabled flow control and Loopback as no loopback. Then click Apply button and these set up items will be applied to port 1/1.

Port list table displays the related information of the switch physical ports.

7.5.1.2Bandwidth control

Click port configuration, Ethernet port configuration, Bandwidth control and proceed to do port bandwidth control. Equals to CLI command 7.2.1.2.1

zPort: Specifies configuration port

176