139
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
& The following is the message displayed when files are successfully received. Otherwise, please
verify link connectivity and retry the “copy” command again.
begin to receive file,wait...
recv 1526037
************************
write ok
transfer complete
close tftp client.
If the switch is upgrading system file or system start up file through TFTP, the switch must not be
restarted until “close tftp client” is displayed, indicating upgrade is successful, otherwise the switch
may be rendered unable to start. If the system file and system start up file upgrade through TFTP
fails, please try to upgrade again or use the BootROM mode to upgrade.
5.6.1 Switch basic configuration
Users should click “Switch basic configuration” table and configure the switch’s clock, prompts of
command-line interface, timeout of quitting privileged configuration mode, etc.
5.6.1.1 Basicconfig
Users should click “Switch basic configuration” and “BasicConfig” to configure the switch’s clock,
prompts of command-line interface and the mapping address relationship with the host.
Basic clock configuration – configure “date and clock” of the system. Please refer to the CLI
command 5.1.1.
Users should configure HH:MM:SS as 23:0:0 and YY.MM.DD as 2002/08/01. The complete
configuration by clicking on the “Apply” button.
z Hostname configuration – configures prompts of command-line interface. Please refer to the
CLI command 5.1.9.
Example: configure the Hostname as “Test” and then click on the “Apply” button to apply this
configuration to the switch.