Accton Technology ES4710BD manual 20.2.2.16 dot1x timeout tx-period, Radius-server accounting host

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

Parameters: <seconds> is the interval for re-authentication, in seconds, the valid range is 1 to 65535.

Command mode: Global Mode

Default: The default value is 3600 seconds.

Usage Guide: dot1x re-authentication must be enabled first before supplicant re-authentication interval can be modified. If authentication is not enabled for the switch, the supplicant re-authentication interval set will not take effect.

Example: Setting the re-authentication time to 1200 seconds. Switch(Config)#dot1x timeout re-authperiod 1200

20.2.2.16 dot1x timeout tx-period

Command: dot1x timeout tx-period <seconds> no dot1x timeout tx-period

Function: Sets the interval for the supplicant to re-transmit EAP request/identity frame; the “no dot1x timeout tx-period” command restores the default setting.

Parameters: <seconds> is the interval for re-transmission of EAP request frames, in seconds; the valid range is 1 to 65535.

Command mode: Global Mode

Default: The default value is 30 seconds.

Usage Guide: Default value is recommended.

Example: Setting the EAP request frame re-transmission interval to 1200 seconds. Switch(Config)#dot1x timeout tx-period 1200

20.2.2.17 radius-server accounting host

Command: radius-server accounting host <ip-address> [port <port-number>] [primary] no radius-server accounting host <ip-address>

Function: Specifies the IP address and listening port number for RADIUS accounting server; the “no radius-server authentication host <IPaddress>” command deletes the RADIUS accounting server

Parameters: <ip-address>stands for the server IP address; <port-number>for server listening port number from 0 to 65535; primary for primary server. Multiple RADIUS sever can be configured and would be available. RADIUS server will be searched by the configured order if primary is not configured, otherwise, the specified RADIUS server will be used first.

Command mode: Global Mode

Default: No RADIUS accounting server is configured by default.

Usage Guide: This command is used to specify the IP address and port number of the specified RADIUS server for switch accounting, multiple command instances can be configured. The <port-number>parameter is used to specify accounting port number, which must be the same as the specified accounting port in the RADIUS server; the default port number is 1813. If this port number is set to 0, accounting port number will be generated at random and can result in invalid configuration. This command can be used repeatedly to configure multiple RADIUS servers communicating with the switch, the switch will send accounting packets to all the configured accounting

518