Accton Technology ES4710BD Passive interface configuration, Sending packet cost configuration

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

18.5.3.2.2 Passive interface configuration

Click “Passive interface configuration” to enter the configuration page. Equivalent to CLI command 18.4.2.2.11.

zPort: port list

zPassive interface configuration: sets up to receive OSPF packets only

zCancel: cancels the setting.

zReset: resets to default parameters

Example: Select port vlan1, select Passive interface configuration and click Apply button to configure port vlan 1 as receiving OSPF packet only.

18.5.3.2.3 Sending packet cost configuration

Click “Sending packet cost configuration” to enter the configuration page.

zVlan port: port list

zOSPF route cost configuration: specifies the cost needed for the OSPF protocol port. Equivalent to CLI command 18.4.2.2.7

zHello packet interval: specifies the interval time to send a hello packet on the ports. Equivalent to CLI command 18.4.2.2.10

zNeighbor router invalid interval: specifies the invalid time length for neighboring Layer 3 switches. Equivalent to CLI command 18.4.2.2.8

zSending link-state packet delay: sets up the value of Sending link-state packet delay on ports. Equals to CLI command 18.4.2.2.14

zSending link-state packet retransmit interval: specifies the Sending link-state packet retransmit interval of the port with neighbor L3 switch. Equivalent to CLI command 18.4.2.2.13

zReset: resets each column value to default in this page and this action will not change settings

zApply: valid each column value. This action will change settings

zDefault: resets to default settings. This action will change settings

452