ES4710BD 10 Slots L2/L3/L4 Chassis Switch

7.2.1.2.11speed-duplex

Command: speed-duplex {auto force10-half force10-full force100-half force100-full { {force1g-half force1g-full} [nonegotiate [master slave]] } }

no speed-duplex

Function: Sets the speed and duplex mode for 1000Base-TX or 100Base-TX ports; the “no speed-duplex command restores the default speed and duplex mode setting, i.e., auto speed negotiation and duplex.

Parameters: auto for auto speed negotiation; force10-halffor forced 10Mbps at half-duplex; force10-fullfor forced 10Mbps at full-duplex mode; force100-halffor forced 100Mbps at half-duplex mode; force100-fullfor forced 100Mbps at full-duplex mode; force1g-halffor forced 1000Mbps at half-duplex mode; force1g-fullfor forced 1000Mbps at full-duplex mode; nonegotiate for disable auto-negotiation for 1000 Mb port; master to force the 1000Mb port to be master mode; slave to force the 1000Mb port to be slave mode.

Command mode: Port configuration Mode

Default: Auto-negotiation for speed and duplex mode is set by default.

Usage Guide: This command applies to 1000Base-TX or 100Base-TX ports only. speed-duplex command is not available for 1000Base-X port. For combo port, this command applies to the 1000Base-TX port only and has no effect on 1000Base-X port. To change the negotiation mode of 1000Base-X port, use negotiation command instead.

When configuring port speed and duplex mode, the speed and duplex mode must be the same as the setting of the remote end, i.e., if the remote device is set to auto-negotiation, then auto-negotiation should be set at the local port. If the remote end is in forced mode, the same should be set in the local end.

1000Gb ports are by default master when configuring nonegotiate mode. If one end is set to master mode, the other end must be set to slave mode. force1g-halfIs not supported yet. Example: Port 1 of Switch 1 is connected to port 1 of Switch2, the following will set both ports in forced 100Mbps at half-duplex mode.

Switch1(Config)#interface e1/1 Switch1(Config-Ethernet1/1)#speed-duplex force100-half Switch2(Config)#interface e1/1 Switch2(Config-Ethernet1/1)#speed-duplex force100-half

7.2.2VLAN Interface Configuration

7.2.2.1VLAN Interface Configuration Task Sequence

1.Enter VLAN Mode

2.Configure the IP address for VLAN interface and enable VLAN interface.

1.Enter VLAN Mode

165

Page 166
Image 166
Accton Technology ES4710BD manual Speed-duplex, Enter Vlan Mode