Accton Technology ES4710BD manual Mac address table configuration, Unicast address configuration

ES4710BD 10 Slots L2/L3/L4 Chassis Switch

8.5.1.3.2MAC Address Binding Troubleshooting Help

Enabling MAC address binding for ports may fail on some occasions. Here are some possible causes and solutions:

&If MAC address binding cannot be enabled for a port, make sure the port is not executing Spanning tree, port aggregation and is not configured as a Trunk port. MAC address binding is exclusive to such configurations. If MAC address binding is to be enabled, the above-mentioned functions must be disabled first.

&If a secure address is set as a static address and deleted, than that secure address will be unusable even though it no longer exists. For this reason, it is recommended to avoid static address for ports enabling MAC address binding.

8.6WEB MANAGEMENT

Click “MAC address table configuration” to open MAC address configuration management list. Users can proceed to manage, set security port, add and delete MAC addresses, and so on.

8.6.1Mac address table configuration

Click “MAC address table configuration”, to open MAC address list configuration management list to manage add delete MAC addresses.

8.6.1.1Unicast address configuration

Click “MAC address table configuration”, “MAC address table configuration”, “unicast address configuration”, “unicast address configuration” to add MAC addresses. Equals to CLI command 8.2.2：

zMAC address: Specifies a MAC address

zVID: The VLAN number of the MAC address

zConfiguration type: static means static address; blackhole means filter address

zPort list: MAC address’s port

zAddress aging-time: Aging time of dynamic MAC addresses

zOperation type: adds/deletes a MAC address

Example:

Set up MAC address as 00-11-11-11-11-11, select VID as 1, configuration type as static; port list as Ethernet 1/1 and address aging-time as 400 seconds. Select operation type as add mac address and click Apply button. Then the set up will be applied to port 1/1.

195