|
| ES4710BD 10 Slots L2/L3/L4 Chassis Switch | ||
（1）show ip ospf |
|
| ||
Example: |
|
|
| |
Switch#show ip ospf |
|
| ||
my router ID is 11.11.4.1 |
|
| ||
preference=10 | ase perference=150 |
|
| |
export metric=1 |
|
|
| |
export |
|
| ||
area ID | 0 |
|
|
|
interface count：1 |
|
| ||
80times spf has been run for this area |
|
| ||
net range： |
|
|
| |
LSRefreshTime is1800 |
|
| ||
area ID | 1 |
|
|
|
interface count：1 |
|
| ||
41times spf has been run for this area |
|
| ||
net range： |
|
|
| |
netid11.11.3.255 | netaddress11.11.0.0 | netmask255.255.252.0 | ||
LSRefreshTime is1800 |
|
| ||
Displayed information |
| Explanation | ||
my router ID |
|
| The ID of the current layer 3 switch | |
preference |
|
| Routing protocol priority | |
ase perference |
|
| Exterior routes priority for introduction | |
export metric |
|
| The hops for output from the port | |
export tag |
|
| The route tag for output from the port | |
area ID |
|
|
| OSPF area number: including statistics for |
interface count |
|
| interface number in the area, SPF algorithm | |
imes spf has been run for this area |
| calculation time and network scope. | ||
net range |
|
|
| |
（2）show ip route
The “show ip route” command can be used to display the information about OSPF routes in the route table: destination IP addresses, network masks, next hop IP addresses, and forwarding interfaces, etc.
For example, displayed information can be: Switch#show ip route
Total route items is 4018, the matched route items is 4018
Codes: C - connected, S - static, R - RIP derived, O - OSPF derived A - OSPF ASE, B - BGP derived, D - DVMRP derived
| Destination | Mask | Nexthop | Interface | Preference |
C | 4.1.140.0 | 255.255.255.0 | 0.0.0.0 | Vlan2139 | 0 |
A | 5.1.1.0 | 255.255.255.0 | 12.1.1.2 | Vlan12 | 150 |
|
|
| 437 |
|
|
