ES4710BD 10 Slots L2/L3/L4 Chassis Switch

zBandwidth control level: port bandwidth control. The unit is Mbps and the value range is 1~10000Mbps

zControl type: Ingress means to control port bandwidth when receiving data packet sent from outside the switch. Egress means to control port bandwidth when sending data packets to outside of the switch. Ingress and Egress means to control port bandwidth when both receiving and sending.

Example: Choose Port to be Ethernet 2/1, set up Bandwidth control level as 100Mb, Control type as Ingress, then click Apply button. So the port 1/1 will execute bandwidth control and receiving data packet with 100M.

Port list table displays the port bandwidth control information of the switch:

7.5.2Vlan interface configuration

Click Port configuration, vlan interface configuration to open the VLAN port configuration management list to allocate IP address and mask on L3 port and so on.

7.5.2.1Allocate IP address for L3 port

Click “Port configuration”, “vlan interface configuration”, Allocate IP address for L3 port to allocate IP address for L3 port. Equals to CLI command 7.2.2.2.2. This setup contains the following characteristics:

zPort: L3 port

zPort IP address: IP address for L3 port

zPort network mask

zPort status

zOperation type: add/delete address

Example: Assign Port as Vlan1, port IP address as 192.168.1.180, Port network mask as 255.255.255.0, Port status as no shutdown, Operation type selection as Add address then click Apply button and this set up will be applied to the switch.

177

Page 178
Image 178
Accton Technology ES4710BD manual Vlan interface configuration, Allocate IP address for L3 port