System Setup
|
| Video | |||
No Disc |
|
|
|
|
|
Programme | TV Aspect | : 16:9 Wide | ► | ||
Setup | 3D Noise Reduction : Off | ► | |||
| Video Output |
| Component |
|
|
| DivX(R) Registration | RGB |
|
| |
|
|
|
|
|
|
MOVE | OK | RETURN | EXIT | ||
|
|
|
|
|
|
▌Video output
•Component : Select this when the DVD Recorder is connected to a TV with Component jack.
•RGB : Select this when the DVD Recorder is connected to your TV using SCART cable.
In Component mode, you can set video output to Progressive(P.SCAN) or Interlace, see below. When the HDMI cable is not connected, available video output jacks are as follow.
Setting mode | Component mode | RGB Mode | |||
Output jack |
|
| |||
P.SCAN off mode (Interlace mode) | P.SCAN on mode | ||||
| |||||
Component Output | O | O | X | ||
(Y, PB, PR) | (TV in progressive mode) | ||||
|
| ||||
AV1 Scart | R, G, B | X | X | O | |
|
|
|
| ||
Composite | O | X | X | ||
| |||||
Composite Video out | O | X | O | ||
|
|
|
| ||
O | X | O | |||
|
|
|
|
|
■ When the HDMI cable is connected, other A/V output does not operate.
Progressive scan
If the TV supports Progressive Scan, press the P.SCAN button on the front of the DVD Recorder to enjoy.
Setting up the Progressive scan
1.With the DVD Recorder in Stop mode, press the P.SCAN button on the front of the DVD Recorder.
The message “Press [Yes] to confirm Progressive scan mode. Otherwise, press [No].” will appear.
2.Press the ◄ ► buttons to select Yes, and then press the OK button.
3.Set your TV to Progressive input (using the TV remote control.)
■ When the HDMI cable is connected, this screen is not displayed.
■Do not press the P.SCAN button if you are using a TV that does not support Progressive mode. Nothing will be displayed on the screen if pressed.
■Progressive setting is only available when the Video Out is set to Component.
■Progressive setting is only available when the DVD recorder is in stop mode.
Canceling the Progressive scan
1.With the DVD Recorder in Stop mode, press the P.SCAN button on the front of the DVD Recorder.
The message “Press [Yes] to confirm Interlace scan mode. Otherwise, press [No].” will appear.
2.Press the ◄ ► buttons to select Yes, and then press the OK button.
3.Set your TV to Interlace input (using the TV remote control.)
■ If you press the P.SCAN button by mistake when your TV does not support Progressive mode, you need to release the Progressive mode. To release the Progressive mode, press the P.SCAN button on the front panel 2 times.
■The screen will recover after the PS
English - 30