2Wire C424 manual WorkCentre C2424 Copier-Printer, Specialty Paper

Specialty Paper

5.On the control panel:

a.Select Change, then press the Enter button.

b.Select the paper size, then press the Enter button.

c.Select Special for paper type, then press the Enter button to save your selection.

6.In the printer driver, select Tray 1 as the paper source.

Note

Do not select Proof Prints during the print job. It will disturb the sequence of the pre-collated sets.

7.To ensure the carbonless paper sets are properly loaded in the tray:

a.Print one complete set.

b.Remove the set from the output tray.

c.Mark the top, white sheet of the printed set with a pen or a pencil.

■If the paper is loaded correctly, the mark should appear on the printed side of the subsequent colored sheets within a few seconds.

■If a mark does not appear, repeat Steps 1–7 to make sure the paper is loaded correctly.

Printing Xerox Carbonless Paper from Tray 2, 3, or 4

1.Pull the tray completely out of the system.

2424-001

WorkCentre® C2424 Copier-Printer

5-45