3M 39600 manual 8 - Knife Warning Label, 9 - Tape Threading Label, 10 - Pinch Point Caution Label

Important Safeguards (Continued)

The following two labels are located on the upper and lower taping heads. Replacement part numbers for these two labels are listed in Section II.

The "Warning-Sharp Knife" label warns operators and service personnel of the extremely sharp knife used to cut the tape at the end of the box sealing operation. The label, shown in Figure 1-8,is located on the orange knife guard between the applying roller assembly and the buffing roller assembly. Never operate taping heads with knife guard removed.

Before working with the taping heads or loading/ threading tape, refer to Figures 3-1 and 3-2, in Section II, to identify the knife location. Keep hands out of these areas except as necessary to service the taping heads or to load/thread tape.

Figure 1-8 – Knife Warning Label

The "Tape Threading Label", shown in Figure 1-9, is attached to the left side of both upper and lower taping heads. This label provides a convenient tape threading diagram. More detailed tape loading and threading information is provided in this manual in the set-up procedure section.

Figure 1-9 – Tape Threading Label

The "Caution – Pinch Point"label, shown in Figure 1-10, is attached next to both compression roller lock knobs on the upper assembly crossbar. The label reminds operator to keep hands away from compression rollers when machine is running.

Figure 1-10 – Pinch Point Caution Label

5