3M 39600 Warnings, Turn electrical supply off when machine is not in use, Emergency Stop Switch

Operation (Continued)

WARNINGS

1.Turn electrical supply off and disconnect before servicing taping heads or performing any adjustments or maintenance on the machine.

2.Turn electrical supply off when machine is not in use.

3.Before turning drive belts on, be sure no tools or other objects are on the machine bed.

4.Keep hands and loose clothing away from moving belts.

5.Never attempt to work on any part of the machine, load tape or remove jammed boxes from the machine while machine is running.

6.When feeding boxes to the machine by hand, push box in from end only – DO NOT PUSH WITH HANDS ON ANY CORNER OF THE BOX.

7.Taping heads utilize an extremely sharp cut-off knife. The knife is located under the orange knife guard that has the 'WARNING – SHARP KNIFE" label. Before loading tape, refer to Section II, page 6, Figures 3-1 and 3-2 to identify the knife location. Keep hands out of these areas except as necessary to service the taping heads.

8.Failure to comply with these warnings could result in severe personal injury and/or equipment damage.

Electrical "On/Off" Switch

The box drive belts are turned on and off ("Off" button is red) with the electrical switch on the side of the machine frame.

Note –The case sealer has a circuit breaker located in the electrical enclosure on the lower left side of the machine frame. If circuit becomes overloaded and circuit breaker trips, see "Maintenance – Circuit Breaker", page 21.

Emergency Stop Switch

The machine electrical supply can be turned off by pressing the latching emergency stop switch. To restart machine, rotate emergency stop switch (releases switch latch) and then restart machine by pressing green (On) button on side of machine frame.

Tape Loading/Threading

See Section II, Pages 7 and 8

Note –If lower tape drum is mounted in alternate lower outboard position, remove taping head from machine bed by pulling straight up, insert threading needle in taping head and replace taping head. Install tape roll on drum (adhesive on tape leg up), thread tape under knurled roller on outboard mount, then attach tape to threading needle and pull tape through taping head with threading needle.

CAUTION – Taping head weighs approximately 7.2 kg [16 pounds]

without tape. Use proper body mechanics when removing or installing taping head.

16