3M 39600 WARNING - Turn off electrical power and disconnect power cord from, Box Height Range

Special Set-Up Procedure (Continued)

WARNING – Turn off electrical power and disconnect power cord from

electrical supply before beginning special set-up procedure, if power cord is not disconnected, severe injury to personnel could result.

Box Height Range

(Outer Column – Re-Positioning)

WARNING – It is recommended that no less than two people assist on this set-

up or severe injury or equipment damage could result.

Moving the outer columns to the upper set of mounting holes increases the maximum box size (height) handled by the case sealer from 620 mm

[24-1/2 inches] to 725 mm [28-1/2 inches]. Note – this also increases the minimum box height from 120 mm [4-3/4 inches] to 210 mm [8-1/4 inches].

To Re-position the outer columns:

1.Remove special nut from the bottom of each column lead screw. Figure 5-4A.

2.Remove plastic column cap from the top of each outer column as shown in Figure 5-4B.

3.Crank upper assembly up, out of plastic nuts. Lift upper assembly up and out of outer columns. Be careful not to damage lead screws. Figure 5-4C.

WARNING – Upper assembly weight is approximately 35 kg [75 lbs]. Lift with

hoist or be sure to have adequate help available to physically lift upper assembly up and out of outer columns.

27