13-MAINTENANCE AND REPAIRS (continued)

Special Set-Up Procedure (continued)

WARNING

To reduce the risk associated with

To reduce the risk associated with

mechanicalmechanicalandandelectricalelectricalhazards:hazards:

Allow only properly trained and Turn electrical and air supply off and

qualified personnel to operate and service disconnect before performing any

this equipment.

adjustments, maintenance, or servicing the

machine or taping heads

WARNING

To reduce the risk associated with muscle strain:

Use the appropriate rigging and material handling equipment when lifting or repositioning this equipment.

Use proper body mechanics when removing or installing taping heads that are moderately heavy or may be considered awkward to lift.

13.11.4Box Height Range

(Outer Column – Re-Positioning)

Moving the outer columns to the upper set of mounting holes increases the maximum box size (height) handled by the case sealer from 620mm [24-1/2 inches] to 725mm [28-1/2 inches].

Note – this also increases the minimum box height from 120mm [4-3/4 inches] to 210mm [8-1/4 inches].

To Re-position the outer columns:

1.Remove special nut from the bottom of each column lead screw. Figure 13-11A.

2.Remove plastic column cap from the top of each outer column as shown in Figure 13-11B.

3.Crank upper assembly up, out of plastic nuts. Lift upper assembly up and out of outer columns. Be careful not to damage lead screws - Figure 13-11C.

800a-NA

2011 August

 

32

Page 44
Image 44
3M 800a manual To reduce the risk associated with, Box Height Range