A&D 1WMPD4002313 manual Data format, Data output mode f06, In “2-3. Command Mode”

The frame ground and the shield are connected internally and there is no difference between them in use.

Data format

‰Example of data

Out of range “kg” (+)

O L

,

+ 9 9 9 9 9 9 9 9 _ k g CR

LF

Out of range “kg” (+)

O L

,

+ 9 9 9 9

.

9 9 9 _ k g CR

LF

The position of decimal point is different according to the model and/or “f02”.

Example for the weighing unit “lb-oz” (added)

Weighing data “lb-oz” (+)

S T

,

+ 0 0 1 L 0 1

.

6 _ o z CR

LF

Data output mode (f06)

The commands can be used in all data output modes (f06-1 is command mode only). The new modes f06-5, f06-6 and f06-7 are added to the Function “f06”.

‰Auto-print Mode + data and OK (f06-6)

Data is sent if the weight display is stable at +5d (d = weighing display division) and above, and the comparator result OK in addition. The next transmission cannot occur until after the weight display falls below +5d.

‰Auto-print Mode +/- data and OK (f06-7)

Data is sent if the weight display is stable at ±5d (d = weighing display division) and above/below, and the comparator result OK in addition. The next transmission cannot occur until after the weight display falls between –5d and +5d.

‰Multi-connection with Print key mode (RS-422/485) (f06-5)

This is one of the applications when a PC and more than one FS-D (RS-422/485 installed) are connected. Refer to “Multi-connection with Print key mode” in detail.

(In “2-3. Command Mode”)

Examples of command and reply (“_” shows “Space” (20H).) There are corrections to the instruction manual 1WMPD4001368.

‰Set a HI limit value or upper limit weight.

When f07-0 or f07-1 is set, the command should have “+” and 6 digit number without decimal point.

‰Set a LO limit value or lower limit weight.

When f07-0 or f07-1 is set, the command should have “+” and 6 digit number without decimal point.

(No reply for f20-1.)

When f07-0 or f07-1 is set, the command should have “+/-” (“+” only for f07-1) and 6 digit number without decimal point.

(No reply for f20-1.)

When f07-0 or f07-1 is set, the command should have “+/-” (“+” only for f07-1) and 6 digit number without decimal point.

When f07-2 is set, the command should have “+” and 5 digit number without decimal point.

16