Station Mode | Abocom None instruction

Station Mode

Profile

Profile can book keeping the favorite wireless setting among home, office, and other public hot-spot. Users may save multiple profiles, and activate the correct one at preference. The Profile manager enables users to Add, Edit, Delete, and Activate profiles.

Click this button to show the information of Status Section.

Click this button to hide the information of Status Section.

Profile Tab

Profile Name

SSID

Network Type

Authentication

Encryption

Use 802.1x

Tx Power

Channel

Users may enter a distinctive name of profile in this column. The default is PROF# (#1, #2, #3....)

The SSID is the unique name shared among all wireless access points in the wireless network.

Shows the network type of the device, including Infrastructure and Ad-hoc.

Shows the authentication mode.

Shows the encryption type.

Whether use 802.1x feature or not.

Transmit power, the amount of power used by a radio transceiver to send the signal out.

Shows the selected channel that is currently in use.

- 37 -

Image 41

Abocom None user manual Station Mode, Network Type Authentication Encryption Use Tx Power Channel

Contents

802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference Statement Table of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction Features Install the Software Chapter InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network Connection Utility Configuration Network Type Authentication Station ModeProfile Profile Tab System Configuration tab Lowest Authentication and Security tab 802.1x tab ID\PASSWORD tab Tunnel AuthenticationEAP Method EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token Card Server Certification tab Client Certification tab Network Tab Network General Access Point AP Information 802.11n Link Status Link Status Tab Advanced Tab Advanced Transmit Statistics Receive Statistics WMM/ QoS Direct Link Setup Enable WMM Enable WMM- Power Save EnableMAC Address Timeout Value Apply Tear Down WMM/QoS Tab WPS Tab WPS AP List Rescan Information PIN Code Config Mode Detail Connect Rotate Disconnect Export Profile Radio On/OffDelete WPS Associate IE WPS Probe IE Auto Progress Bar Status Bar About Utility Menu List Config Soft AP modeConfig Channel Wireless Mode Use Mac Address Security Setting Beacon ms TX Power Idle time60-3600s Access Control MAC Table Access Control Event Log Power Saving Mode StatusMAC Table Event Log Transmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX Burst Receive Statistics Tab Reset Counter Click this button to reset counters to zeroTransmit Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Probe IE Progress Bar Status Bar Rotate DisconnectWPS Associate IE Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Clients Hide Ssid Among wirelessNo forwarding Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation