PRINTERPLUG
DVIEXTENDING
SOCKET
USBA
PLUG
D-SUBPLUG
DVIEXTENDING
SOCKET
USBA
SOCKET
1 Writing EDID Procedure
Hardware Configuration:
1.)Connect the PRINTER PLUG of DDC FIXTURE with the
printer port of Desktop PC. (Refer to figure 1)
2.)Plug USB A PLUG of DDC FIXTURE to USB socket of
Desktop PC (Refer to figure 2)
3.)Extend the DVI cable on DVI EXTENDING SOCKET of DDC
FIXTURE. (Refer to figure 3)
4.1)Connect the D-sub plug of Chroma with D-SUB PLUG of
DDC FIXTURE (Refer to figure 4)
4.2) Take a video cable then connect the D-SUB PLUG and the
D-sub socket of monitor. (Refer to figure 5)
5.)Connect the extended DVI cable to DVI socket of monitor
(Refer to figure 5)
6.)Re-confirm all the connectors are connected well.
123
456
CAUTION:The timing of Chroma shall be setup at T254/ P41
beforedata recording. the detail setting parameter from
chroma.Please See below photo
2.Writing VGA/DVI Process
Chosethe folder:”Acer-VGA&DVI” then double click
Selectthe “Acer-M1&M3-XPEDID-DVI-.exe” to execute it
3.SelectModel: Key in password”cedid” then select model
whichone you want to write EDID code that it depends on
paneltype.
cedid
33
Go to cover page
7.Writing EDID Process
ACERG24