Acer R910 manual Removing DIMMs

75

8Install the memory board DIMM cover on the memory board:

(1)Align the DIMM cover tabs with the top of the memory board

(A).

(2)Press the retainer tab inward (B).

(3)Press the DIMM cover down until it clicks into place.

9Install the memory board. For instructions, see “Hot-insertion of a Memory Board” on page 54 or “Cold Insertion of a Memory Board”on page 71, depending on your server configuration.

10Observe the post-installation instructions described on page 34.

Removing DIMMs

Before you can install a new DIMM in a socket, remove first any previously installed DIMM from that socket.

Important: Before removing any DIMM from the mainboard, make sure to create a backup file of all important data.

Caution! Use extreme care when removing DIMMs. Too much pressure can damage the connector. Apply only enough pressure on the plastic levers to release the DIMM.

1Perform steps 1 to 5 described in the “Installing DIMMs” section.

2Gently pull the DIMM upward to remove it from the socket.